Table of Contents
The RSX Type S is a popular choice among car enthusiasts looking to enhance performance. One of the most effective modifications is installing a K&N intake system. This guide will walk you through the installation process and outline the performance benefits you can expect.
Why Choose a K&N Intake?
K&N is renowned for high-performance air filters and intake systems. Here are some reasons why you might consider a K&N intake for your RSX Type S:
- Increased Horsepower: A K&N intake can improve horsepower by allowing your engine to breathe better.
- Improved Throttle Response: Enhanced airflow leads to quicker throttle response.
- Better Fuel Efficiency: More efficient air intake can lead to improved fuel economy.
- Easy Installation: Designed for straightforward installation with minimal tools required.
- Reusable Filters: K&N filters are washable and reusable, reducing waste.
Tools and Materials Needed
Before you begin, gather the following tools and materials:
- Flathead screwdriver
- Phillips screwdriver
- Socket wrench set
- Ratchet
- Torque wrench
- K&N intake kit specific for RSX Type S
- Shop towels
- Safety glasses
Step-by-Step Installation Guide
Step 1: Prepare Your Vehicle
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Disconnect the negative battery terminal to prevent any electrical issues.
Step 2: Remove the Stock Intake System
Begin by loosening the clamps that secure the stock intake tubing to the throttle body and the airbox. Use the flathead screwdriver to loosen the clamps and gently pull the tubing off. Remove any mounting bolts or screws holding the airbox in place, and take out the stock air filter.
Step 3: Install the K&N Intake Tube
Take the K&N intake tube and position it where the stock intake was located. Secure it to the throttle body with the provided clamp. Ensure it is tight but avoid over-tightening to prevent damage.
Step 4: Attach the K&N Filter
Next, attach the K&N air filter to the end of the intake tube. Ensure it is seated properly and secure it with the provided clamp. Make sure there are no gaps between the filter and the tube.
Step 5: Secure All Connections
Go through all connections to ensure everything is tight and secure. Check that the intake tube does not interfere with any moving parts in the engine bay.
Step 6: Reconnect the Battery
Once everything is installed and checked, reconnect the negative battery terminal. Start the engine and listen for any unusual noises, which might indicate a loose connection.
Step 7: Test Drive
Take your RSX Type S for a test drive. Pay attention to the throttle response and overall performance. You should notice a more aggressive sound and improved acceleration.
Performance Benefits of a K&N Intake
After installing a K&N intake, many drivers report noticeable improvements. Here are some of the key performance benefits:
- Enhanced Engine Performance: Increased airflow leads to better combustion and power output.
- Improved Airflow: The K&N filter allows for higher volumes of air, which is crucial for performance engines.
- Long-Term Savings: Reusable filters save money over time compared to disposable filters.
- Better Sound: Many enthusiasts enjoy the deeper, more aggressive sound of an aftermarket intake.
- Increased Resale Value: Performance modifications can enhance the appeal of your vehicle to potential buyers.
Conclusion
Installing a K&N intake on your RSX Type S is a straightforward process that can yield significant performance benefits. With improved horsepower, throttle response, and overall engine efficiency, this modification is a favorite among car enthusiasts. Follow this guide to enhance your driving experience and enjoy the benefits of a K&N intake system.