Installing Edelbrock Performer Rpm Intake on Your A-body Mopar: a Complete Step-by-step Guide

by

Installing an Edelbrock Performer RPM intake manifold on your A-body Mopar can significantly enhance your vehicle’s performance. This guide will walk you through the installation process step-by-step, ensuring you achieve the best results.

Tools and Materials Needed

  • Edelbrock Performer RPM intake manifold
  • Intake manifold gasket set
  • Torque wrench
  • Socket set
  • Ratchet
  • Extension bars
  • Engine cleaner
  • Rags
  • Thread sealant
  • Basic hand tools

Preparation Steps

Before you begin the installation, make sure to prepare your workspace and vehicle. Follow these steps:

  • Disconnect the battery to prevent any electrical issues.
  • Remove any components obstructing access to the intake manifold, such as air cleaner, throttle linkage, and any vacuum lines.
  • Clean the engine surface thoroughly to ensure a proper seal.

Removing the Old Intake Manifold

To install the new intake manifold, you need to remove the old one. Here’s how:

  • Loosen and remove the bolts securing the old intake manifold using a socket and ratchet.
  • Carefully lift the old manifold off the engine block.
  • Inspect the old gaskets and clean off any residue left on the engine surface.

Installing the Edelbrock Performer RPM Intake

Now that the old manifold is removed, you can install the Edelbrock Performer RPM intake:

  • Place the new intake manifold gasket onto the engine block, ensuring it aligns properly with the ports.
  • Carefully position the Edelbrock Performer RPM intake manifold onto the gasket.
  • Install the intake manifold bolts and hand-tighten them initially.

Torque Specifications

Refer to the Edelbrock manual for the correct torque specifications. Generally, the torque sequence follows a specific pattern:

  • Start from the center bolts and work outward.
  • Use a torque wrench to tighten the bolts to the specified torque value.

Reconnecting Components

Once the intake manifold is securely in place, reconnect all previously removed components:

  • Reattach the throttle linkage and vacuum lines.
  • Install the air cleaner back onto the carburetor.
  • Reconnect the battery.

Final Checks and Testing

After everything is reconnected, perform the following checks:

  • Check for any loose connections or leaks around the intake manifold.
  • Start the engine and let it idle for a few minutes.
  • Monitor the engine for any unusual sounds or vibrations.

Conclusion

Installing the Edelbrock Performer RPM intake manifold on your A-body Mopar can be a rewarding experience that enhances your vehicle’s performance. Following this step-by-step guide will help ensure a successful installation. Enjoy your improved ride!