Table of Contents
The Mitsubishi Evo 9 is a legendary vehicle among car enthusiasts, particularly for its performance capabilities. One of the most effective upgrades for enhancing its power and sound is installing a turboback exhaust system. This article will guide you through the process of installing a turboback exhaust in just three hours.
Understanding the Turboback Exhaust System
A turboback exhaust system consists of components that replace the factory exhaust system from the turbocharger to the rear of the vehicle. This upgrade can significantly improve exhaust flow, which leads to better performance and a more aggressive sound.
Benefits of a Turboback Exhaust for the Evo 9
- Increased Horsepower: A turboback exhaust allows for better airflow, resulting in increased horsepower and torque.
- Improved Sound: The exhaust note becomes deeper and more aggressive, enhancing the driving experience.
- Weight Reduction: Aftermarket exhausts are often lighter than stock systems, contributing to overall vehicle performance.
- Enhanced Turbo Response: Reduced back pressure helps the turbo spool faster, improving throttle response.
Tools and Materials Needed
- Tools:
- Socket set
- Wrench set
- Torque wrench
- Jack and jack stands
- Cutting tool (if necessary)
- Rubber mallet
- Safety glasses
- Gloves
- Materials:
- Turboback exhaust system
- Exhaust gaskets
- New bolts (if required)
- High-temperature exhaust sealant (optional)
Preparation Steps
Before starting the installation, ensure that you have all the necessary tools and materials on hand. It’s also crucial to work in a well-ventilated area and wear safety equipment.
1. Raise the Vehicle
Use a jack to lift the vehicle and secure it with jack stands. This will provide you with enough room to work under the car comfortably.
2. Remove the Stock Exhaust
Start by disconnecting the stock exhaust system. Begin at the turbo and work your way back. If necessary, use a cutting tool to remove any sections that are difficult to detach. Make sure to keep any bolts or gaskets that are reusable.
Installing the Turboback Exhaust
1. Install the Downpipe
Begin the installation with the downpipe. Align it with the turbo and secure it using the appropriate bolts and gaskets. Ensure that it is tight and properly sealed to prevent any exhaust leaks.
2. Attach the Mid-Pipe
Next, connect the mid-pipe to the downpipe. Use the provided clamps or hangers to secure it in place. Make sure that it is positioned correctly to avoid any contact with the vehicle’s undercarriage.
3. Install the Axle-Back Section
Finally, attach the axle-back section of the exhaust. Ensure that it lines up with the mid-pipe and secure it using the clamps. Double-check all connections for tightness and proper alignment.
Final Steps
After the installation is complete, it’s essential to perform a few final checks. Start the engine and listen for any unusual sounds that may indicate a leak. If everything sounds good, lower the vehicle back to the ground.
Conclusion
Installing a turboback exhaust on your Mitsubishi Evo 9 can be a rewarding upgrade that enhances both performance and sound. With the right tools and a bit of patience, you can complete the installation in just three hours. Enjoy the benefits of improved horsepower and a more aggressive exhaust note!