Step-by-step Guide to Installing the Awe Tuning Cold Air Intake on Your S3 2.0 Tfsi

by

Installing the AWE Tuning Cold Air Intake on your S3 2.0 TFSI can significantly enhance your vehicle’s performance. This step-by-step guide will walk you through the installation process, ensuring you have all the necessary tools and knowledge to complete the task efficiently.

Tools and Materials Needed

  • AWE Tuning Cold Air Intake Kit
  • Socket wrench set
  • Flathead screwdriver
  • Torx bit set
  • Rubber gloves
  • Shop towel
  • Safety glasses

Preparation Steps

Before starting the installation, ensure your vehicle is parked on a flat surface, and the engine is cool. Gather all tools and materials, and wear safety glasses and gloves for protection.

Step 1: Remove the Engine Cover

Using a socket wrench, remove the screws securing the engine cover. Carefully lift the cover off and set it aside.

Step 2: Disconnect the Air Intake Hose

Locate the air intake hose connected to the factory air box. Use a flathead screwdriver to loosen the clamp and disconnect the hose from the air box.

Step 3: Remove the Factory Air Box

Unscrew the screws holding the factory air box in place using a socket wrench. Carefully lift the air box out of the engine bay and set it aside.

Step 4: Install the AWE Tuning Air Filter

Take the AWE Tuning air filter from the kit. Align it with the intake tube and push it into place until it is secure.

Step 5: Attach the New Intake Tube

Connect the new intake tube to the air filter. Ensure it is properly aligned and secure it with the provided clamp.

Step 6: Secure the New Air Box

Place the new air box into the engine bay. Make sure it is positioned correctly and secure it with the screws you removed earlier.

Step 7: Reconnect the Air Intake Hose

Reconnect the air intake hose to the new air box. Tighten the clamp securely to prevent any air leaks.

Step 8: Replace the Engine Cover

Finally, place the engine cover back onto the engine bay and secure it with the screws you removed initially.

Final Checks

Once everything is secured, double-check all connections and ensure that there are no loose parts. Start your engine and listen for any unusual noises. If everything sounds good, take your S3 for a test drive to experience the improved performance.

Conclusion

Installing the AWE Tuning Cold Air Intake on your S3 2.0 TFSI is a straightforward process that can enhance your vehicle’s performance and efficiency. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of your new intake system.