Table of Contents
The BMC Turbo Kit is a popular upgrade for the E92 M3, significantly enhancing its performance. This article provides a comprehensive, step-by-step guide to installing the BMC Turbo Kit on your E92 M3.
Tools and Materials Needed
- Basic hand tools (screwdrivers, wrenches, pliers)
- Torque wrench
- Socket set
- Jack and jack stands
- BMC Turbo Kit
- Installation manual
- Safety goggles and gloves
Preparation Steps
Before starting the installation, ensure you have all the necessary tools and materials. Additionally, park your E92 M3 on a flat surface and allow the engine to cool down completely.
1. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation process.
2. Lift the Vehicle
Using a jack, lift the front of your E92 M3 and secure it with jack stands. This will provide you with adequate space to work underneath the vehicle.
Removing the Stock Components
To install the BMC Turbo Kit, you must first remove the stock components that will be replaced.
1. Remove the Stock Air Intake
Start by loosening the clamps on the stock air intake and carefully remove it from the engine bay. Be cautious of any clips or sensors attached to the intake.
2. Disconnect the Stock Turbo
Next, disconnect the stock turbo by removing the necessary bolts and clamps. Ensure that you have a container ready to catch any oil or fluids that may leak out.
Installing the BMC Turbo Kit
With the stock components removed, you can now proceed to install the BMC Turbo Kit.
1. Install the New Turbo
Carefully position the new turbo into place. Align it with the mounting points and secure it using the supplied bolts. Be sure to torque them to the manufacturer’s specifications.
2. Attach the New Air Intake
Install the new air intake that comes with the BMC Turbo Kit. Ensure that it is properly secured and that all clamps are tightened.
Connecting the Necessary Hoses
After installing the turbo and air intake, connect the necessary hoses that are part of the BMC Turbo Kit.
1. Oil and Coolant Lines
Attach the oil and coolant lines according to the installation manual. Ensure that all connections are secure to prevent leaks.
2. Vacuum Hoses
Connect any vacuum hoses included in the kit. Make sure they are routed correctly and securely fastened.
Final Steps
Once everything is installed, there are a few final steps to complete the installation process.
1. Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure that it is tight and secure.
2. Start the Engine
Start the engine and let it idle for a few minutes. Check for any leaks or unusual noises. If everything sounds good, take the vehicle for a test drive.
Conclusion
Installing the BMC Turbo Kit on your E92 M3 can significantly enhance its performance. By following this step-by-step guide, you can complete the installation with confidence. Always refer to the installation manual for specific details and torque specifications.