Table of Contents
Installing a Ram Power Wagon supercharger on your Wrangler JL can significantly enhance its performance. This guide will walk you through the installation process step-by-step, ensuring that you have the information needed for a successful upgrade.
Tools and Materials Needed
- Ram Power Wagon Supercharger Kit
- Socket set
- Wrenches
- Torque wrench
- Ratchet
- Flathead and Phillips screwdrivers
- Wire cutters
- Electrical tape
- Gasket maker
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure that your Wrangler JL is parked on a flat surface. Disconnect the battery to prevent any electrical issues during the process. Wear safety glasses and gloves for protection.
Step 1: Remove the Engine Cover
Using a socket set, remove the bolts securing the engine cover. Carefully lift the cover off and set it aside.
Step 2: Disconnect the Air Intake
Loosen the clamps on the air intake hose and disconnect it from the throttle body. Remove any sensors or attachments connected to the intake for easier access.
Step 3: Remove the Factory Supercharger (if applicable)
If your Wrangler JL is equipped with a factory supercharger, carefully remove it by unscrewing the bolts and disconnecting any associated wiring. Make sure to keep all components organized for reinstallation.
Installing the Ram Power Wagon Supercharger
Step 4: Prepare the New Supercharger
Unbox the Ram Power Wagon supercharger kit and lay out all components. Review the installation manual for any specific instructions related to your model.
Step 5: Install the Supercharger Base
Apply gasket maker to the base of the supercharger. Position it onto the engine and secure it with the provided bolts. Use a torque wrench to tighten the bolts to the specified torque in the manual.
Step 6: Attach the Supercharger
Carefully place the supercharger onto the base and align it with the mounting holes. Secure it with the appropriate bolts, ensuring everything is tightened properly.
Step 7: Reconnect the Air Intake
Reconnect the air intake hose to the throttle body and secure it with clamps. Reattach any sensors or attachments that were disconnected earlier.
Final Steps
Step 8: Reinstall the Engine Cover
Place the engine cover back onto the engine and secure it with the previously removed bolts. Ensure everything is snug and in place.
Step 9: Reconnect the Battery
Reconnect the battery terminals, ensuring the connections are tight. This will allow the vehicle to power up and run the new supercharger.
Step 10: Test the Installation
Start your Wrangler JL and let it idle for a few minutes. Check for any unusual noises or leaks. Take the vehicle for a test drive to ensure the supercharger is functioning properly.
Troubleshooting Common Issues
If you encounter any issues during or after installation, consider the following troubleshooting tips:
- Check all connections to ensure they are secure.
- Inspect for any vacuum leaks around the supercharger.
- Verify that all sensors are properly connected.
- Consult the installation manual for specific error codes or troubleshooting advice.
Conclusion
Installing a Ram Power Wagon supercharger on your Wrangler JL can greatly enhance its performance and driving experience. By following these step-by-step instructions, you can successfully complete the installation and enjoy the benefits of increased power and torque.