Table of Contents
Upgrading your vehicle’s performance can significantly enhance your driving experience. This guide will walk you through the installation of Akrapovič exhausts and H&R springs for the 11 Turbo model. With the right tools and a bit of patience, you can achieve a turbocharged performance upgrade.
Tools and Materials Needed
- Socket set
- Wrench set
- Torque wrench
- Jack and jack stands
- Safety goggles
- Gloves
- Akrapovič exhaust system
- H&R springs
- Spring compressor (optional)
Safety Precautions
Before starting any modifications, ensure you take the necessary safety precautions. Always wear safety goggles and gloves to protect yourself from debris and sharp edges. Work in a well-ventilated area, and make sure the vehicle is securely lifted and supported.
Step 1: Preparing the Vehicle
Begin by parking your vehicle on a flat surface. Engage the parking brake and disconnect the battery to prevent any electrical issues during installation. Use a jack to lift the vehicle and place it securely on jack stands.
Step 2: Removing the Existing Exhaust System
Start at the rear of the vehicle. Locate the existing exhaust system and identify the mounting points. Use your socket set to remove the bolts securing the exhaust to the vehicle. Carefully detach the exhaust system from the hangers and remove it completely.
Step 3: Installing the Akrapovič Exhaust
With the old exhaust removed, it’s time to install the Akrapovič exhaust. Begin by positioning the new exhaust system into place. Align it with the mounting points and hangers. Use the provided hardware to secure the exhaust, ensuring all bolts are tightened to the manufacturer’s specifications.
Step 4: Removing the Stock Springs
Next, move on to the suspension system. Remove the wheels to access the springs. Depending on your vehicle setup, you may need to use a spring compressor to safely remove the stock springs. Loosen and remove the bolts securing the struts and carefully detach the springs from the strut assembly.
Step 5: Installing H&R Springs
Once the stock springs are removed, take the H&R springs and position them onto the strut assembly. Ensure they are seated correctly. Reattach the strut assembly to the vehicle, tightening all bolts to the specified torque settings. If you used a spring compressor, carefully release it once everything is secured.
Step 6: Reinstalling the Wheels
After the new springs are installed, it’s time to put the wheels back on. Align the wheels with the hub and hand-tighten the lug nuts. Once all wheels are in place, lower the vehicle back to the ground and use a torque wrench to tighten the lug nuts to the manufacturer’s specifications.
Step 7: Final Checks
With everything installed, reconnect the battery. Start the vehicle and listen for any unusual noises from the exhaust. Check the alignment of the springs and ensure everything is secure. It’s advisable to take the vehicle for a short drive to ensure proper functionality and performance.
Conclusion
Upgrading to Akrapovič exhausts and H&R springs can significantly enhance your 11 Turbo’s performance and handling. By following this guide, you can ensure a successful installation. Enjoy your improved driving experience!