Table of Contents
Upgrading your turbocharger can significantly enhance your vehicle’s performance. In this guide, we will walk you through the process of upgrading to a 35B compressor wheel for your 3B turbo. This upgrade is designed to improve airflow and boost, resulting in better throttle response and increased power output.
Tools and Materials Needed
- Socket set
- Torque wrench
- Flathead and Phillips screwdrivers
- Turbocharger rebuild kit
- 35B compressor wheel
- Gasket sealant
- Clean rags
- Safety goggles
- Gloves
Preparation Steps
Before starting the installation, ensure that you have all the necessary tools and materials at hand. Follow these preparation steps:
- Disconnect the battery to prevent electrical issues.
- Remove the intake and exhaust components connected to the turbocharger.
- Drain the engine oil to avoid spills during the upgrade.
- Clean the work area to ensure a safe and efficient installation process.
Removing the Old Turbocharger
To install the 35B compressor wheel, you will first need to remove the existing turbocharger. Follow these steps:
- Using a socket set, unbolt the turbocharger from the exhaust manifold.
- Disconnect the oil feed and return lines from the turbo.
- Carefully lift the turbocharger out of the engine bay.
- Inspect the old turbo for any signs of damage or wear.
Disassembling the Turbocharger
Once the turbocharger is removed, you will need to disassemble it to replace the compressor wheel. Follow these steps:
- Remove the compressor housing by unscrewing the bolts.
- Carefully detach the old compressor wheel from the shaft.
- Inspect the shaft for any signs of wear or damage.
- Clean the compressor housing thoroughly with a clean rag.
Installing the 35B Compressor Wheel
Now that you have the turbocharger disassembled, it’s time to install the new 35B compressor wheel. Follow these steps:
- Apply a small amount of oil to the shaft to facilitate installation.
- Carefully place the 35B compressor wheel onto the shaft, ensuring it fits snugly.
- Reattach the compressor housing and secure it with the bolts.
- Ensure everything is tightened to the manufacturer’s specifications using a torque wrench.
Reassembling the Turbocharger
With the new compressor wheel installed, it’s time to reassemble the turbocharger. Follow these steps:
- Reinstall any components that were removed during disassembly.
- Check all seals and gaskets; replace them as necessary.
- Apply gasket sealant to ensure a tight seal.
- Double-check all bolts and connections for proper tightness.
Reinstalling the Turbocharger
Now that the turbocharger is reassembled, it can be reinstalled in the engine bay. Follow these steps:
- Carefully position the turbocharger back into place.
- Reconnect the oil feed and return lines.
- Secure the turbocharger to the exhaust manifold using the bolts.
- Reattach the intake and exhaust components that were removed earlier.
Final Steps and Testing
After reinstalling the turbocharger, there are a few final steps to complete:
- Reconnect the battery.
- Refill the engine oil to the appropriate level.
- Start the engine and let it idle for a few minutes.
- Check for any leaks around the turbocharger and lines.
- Take the vehicle for a test drive to ensure everything is functioning properly.
Conclusion
Upgrading to a 35B compressor wheel can greatly enhance your vehicle’s performance. By following this installation guide, you can ensure a successful upgrade. Always remember to prioritize safety and consult a professional if you encounter any issues during the installation process.