Table of Contents
The AC Integra Type R is a beloved vehicle among car enthusiasts, known for its performance and tuning potential. One of the most effective modifications to enhance its performance is the installation of a cold air intake. This guide will walk you through the step-by-step process of installing an AC Integra Type R cold air intake, complete with dyno results showing an impressive gain of +15 horsepower.
Tools and Materials Needed
- AC Integra Type R cold air intake kit
- Socket set
- Wrenches
- Flathead screwdriver
- Phillips screwdriver
- Rubber gloves
- Shop towels
- Dyno tuning service (optional)
Step 1: Preparing the Vehicle
Before starting the installation, ensure that your vehicle is parked on a flat surface and the engine is cool. It’s also advisable to disconnect the battery to prevent any electrical issues during the process.
Step 2: Removing the Stock Air Intake
Begin by removing the stock air intake system. Follow these sub-steps:
- Locate the air intake box and remove the screws using a socket set.
- Disconnect the mass air flow (MAF) sensor by gently pulling on the connector.
- Remove any hoses connected to the intake and set them aside.
- Take out the air filter and the intake tube from the engine bay.
Step 3: Installing the Cold Air Intake
Now that the stock intake is removed, it’s time to install the new cold air intake. Follow these steps:
- Position the new cold air intake tube in the engine bay.
- Connect the MAF sensor to the new intake tube.
- Secure the intake tube in place using the provided clamps.
- Attach the new air filter to the end of the intake tube.
- Reconnect any hoses that were removed during the process.
Step 4: Final Checks and Reconnection
After installing the cold air intake, it’s crucial to double-check all connections and components. Ensure that:
- All clamps are tightened securely.
- Hoses are reconnected properly.
- The MAF sensor connector is firmly attached.
Once everything is checked, reconnect the battery.
Step 5: Testing the Installation
Start the engine and let it idle for a few minutes. Listen for any unusual sounds and check for any leaks around the intake. If everything sounds normal, take the car for a test drive to feel the difference in performance.
Dyno Results
To quantify the performance gains from the cold air intake installation, a dyno test was conducted. The results showed a remarkable increase of +15 horsepower. Here’s a summary of the dyno results:
- Stock horsepower: 180 hp
- Post-installation horsepower: 195 hp
- Increase: +15 hp
Conclusion
Installing a cold air intake on your AC Integra Type R is a straightforward process that can significantly enhance your vehicle’s performance. With the right tools and careful attention to detail, you can achieve a gain of +15 horsepower, making your driving experience even more enjoyable. Happy driving!