Table of Contents
Installing a cold air intake is one of the most effective ways to boost your Mustang GT’s performance. The AEM 21-802C Cold Air Intake is designed to enhance airflow, increase horsepower, and improve engine sound. This guide will walk you through the installation process step-by-step.
What You Will Need
- AEM 21-802C Cold Air Intake Kit
- Socket set
- Ratchet
- Torque wrench
- Flathead screwdriver
- Phillips screwdriver
- Shop towel
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure you are working in a clean, dry area. Gather all your tools and the AEM 21-802C Cold Air Intake kit. It’s also important to wear safety glasses and gloves to protect yourself during the installation process.
Step-by-Step Installation Process
Step 1: Remove the Factory Air Intake
Start by opening the hood of your Mustang GT. Locate the factory air intake system. Use the socket set to remove the bolts securing the air intake duct to the throttle body. Disconnect any sensors or hoses attached to the intake.
Once everything is disconnected, carefully remove the factory air intake from the engine bay. Make sure to keep track of any screws or components for later use.
Step 2: Install the AEM Cold Air Intake
Take the AEM 21-802C Cold Air Intake out of the box. Begin by attaching the filter to the intake tube. Make sure the connection is secure. Next, position the intake tube in the engine bay where the factory intake was located.
Align the intake tube with the throttle body and secure it using the provided clamps. Tighten the clamps using the socket set, ensuring a snug fit without over-tightening.
Step 3: Reconnect Sensors and Hoses
Reconnect any sensors or hoses that were disconnected during the removal of the factory intake. Make sure they are securely attached and not pinched or damaged.
Step 4: Final Checks
Before closing the hood, double-check all connections and fittings. Ensure that there are no loose bolts or clamps. It’s crucial to verify that everything is properly secured to avoid any issues while driving.
Post-Installation Tips
After the installation, it’s advisable to take your Mustang GT for a test drive. Pay attention to the engine sound and performance. You should notice an improvement in throttle response and overall power.
Additionally, consider checking the air filter periodically to ensure it is clean and functioning properly. AEM recommends cleaning the filter every 25,000 miles or as needed, depending on driving conditions.
Conclusion
The AEM 21-802C Cold Air Intake is a fantastic upgrade for any Mustang GT owner looking to enhance their vehicle’s performance. With proper installation, you can enjoy increased horsepower and a more aggressive engine sound. Follow this guide to ensure a smooth installation process and happy driving!