Table of Contents
Installing an AEM 70mm throttle body on your Mustang can significantly enhance its performance. This guide will walk you through the process step-by-step, ensuring you have all the information needed for a successful installation.
Tools and Materials Needed
- AEM 70mm Throttle Body
- Socket set
- Torque wrench
- Flathead screwdriver
- Phillips screwdriver
- Throttle body gasket
- Vacuum hose (if needed)
- Shop towels
Preparation
Before beginning the installation, ensure your Mustang is parked on a flat surface and the engine is cool. Disconnect the negative battery terminal to prevent any electrical issues during the installation process.
Removing the Stock Throttle Body
Follow these steps to remove the stock throttle body:
- Locate the throttle body on the intake manifold.
- Disconnect the electrical connectors from the throttle position sensor and any other sensors attached to the throttle body.
- Remove the vacuum hoses connected to the throttle body.
- Using the socket set, unscrew the bolts securing the throttle body to the intake manifold.
- Carefully lift the throttle body off the manifold, ensuring the gasket remains intact or is removed if damaged.
Installing the AEM 70mm Throttle Body
Now that the stock throttle body is removed, follow these steps to install the AEM 70mm throttle body:
- Place the new throttle body gasket onto the intake manifold.
- Align the AEM 70mm throttle body with the gasket and intake manifold.
- Using the socket set, secure the throttle body with the bolts, tightening them to the manufacturer’s specifications.
- Reconnect the vacuum hoses to the throttle body.
- Reconnect the electrical connectors to the throttle position sensor and other sensors.
Final Checks
Before starting the engine, it’s important to perform a few final checks:
- Ensure all bolts are tightened securely.
- Check that all vacuum hoses are properly connected.
- Verify that all electrical connections are secure.
Reconnecting the Battery and Testing
With everything installed and checked, reconnect the negative battery terminal. Start the engine and let it idle for a few minutes. Observe the throttle response and listen for any unusual sounds.
Tuning Your Mustang
After installation, it is recommended to tune your Mustang to optimize performance with the new throttle body. Consider using a performance tuning software or consulting with a professional tuner.
Conclusion
The installation of an AEM 70mm throttle body can significantly enhance your Mustang’s performance. By following this guide, you can ensure a smooth installation process and enjoy the benefits of improved throttle response and horsepower.