Table of Contents
The BRZ Supercharger Installation Guide provides a detailed walkthrough for installing the Vortech V-3 Si 10 PSI system. This guide is designed for both experienced mechanics and enthusiasts looking to enhance their vehicle’s performance.
Tools and Materials Needed
- Vortech V-3 Si Supercharger Kit
- Socket set (metric)
- Torque wrench
- Wrenches (metric)
- Flathead screwdriver
- Phillips screwdriver
- Wire cutter/stripper
- Electrical tape
- Coolant
- Oil (engine and supercharger)
Preparation Steps
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Gather all the tools and materials listed above for a smooth installation process.
Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical issues during installation.
Drain Coolant
Drain the engine coolant to avoid spills during the installation. This can be done by locating the drain plug at the bottom of the radiator.
Removing Existing Components
To install the Vortech V-3 Si supercharger, you will need to remove several existing components from your BRZ.
Remove the Intake Manifold
Carefully remove the intake manifold by loosening the bolts and disconnecting any sensors or hoses attached to it. Set it aside in a safe location.
Remove the Stock Airbox
Next, remove the stock airbox and intake tubing. This will create space for the supercharger installation.
Installing the Vortech V-3 Si Supercharger
With the existing components removed, you can now begin the installation of the Vortech V-3 Si supercharger.
Mount the Supercharger Bracket
Start by mounting the supercharger bracket to the engine using the provided bolts. Ensure it is securely fastened according to the torque specifications in the kit’s manual.
Install the Supercharger
Position the Vortech V-3 Si supercharger onto the bracket and secure it with the supplied hardware. Make sure all connections are tight and properly aligned.
Connect the Intake Piping
Attach the intake piping from the supercharger to the throttle body. Ensure all clamps are tightened and there are no leaks in the system.
Reassembly Steps
After installing the supercharger, it’s time to reassemble the components that were removed earlier.
Reinstall the Intake Manifold
Carefully place the intake manifold back onto the engine, reconnecting all sensors and hoses as you go. Tighten the bolts to the specified torque settings.
Reinstall the Stock Airbox
Reattach the stock airbox and intake tubing, ensuring everything is secure and properly positioned.
Final Steps
With all components reassembled, you can proceed to finalize the installation.
Reconnect the Battery
Reconnect the negative terminal of the battery and ensure it is tight.
Refill Coolant
Refill the coolant reservoir with the appropriate coolant mixture, checking for any leaks as you do so.
Check Oil Levels
Check the engine and supercharger oil levels, topping off as necessary to ensure proper operation.
Testing the Installation
Before taking your vehicle for a drive, it’s crucial to test the installation to ensure everything is functioning correctly.
Start the Engine
Start the engine and listen for any unusual noises. Ensure the supercharger is engaging properly.
Check for Leaks
Inspect all connections and hoses for any signs of leaks. Address any issues before proceeding.
Test Drive
Once satisfied with the installation, take your BRZ for a test drive to experience the enhanced performance of the Vortech V-3 Si supercharger.
Conclusion
The Vortech V-3 Si 10 PSI supercharger installation can significantly enhance the performance of your BRZ. By following this guide, you can ensure a successful installation and enjoy the benefits of increased horsepower and torque.