Table of Contents
The Civic Type R is known for its performance and agility, and upgrading its turbocharger can significantly enhance its capabilities. In this guide, we will walk you through the step-by-step installation of the Garrett GTW2860R turbo upgrade, ensuring you get the most out of your Civic Type R.
Tools and Materials Required
- Garrett GTW2860R Turbocharger
- Turbo Installation Kit
- Socket Set
- Wrenches
- Torque Wrench
- Oil Line Kit
- Coolant Line Kit
- Intercooler Piping
- Gaskets and Seals
- Engine Oil
- Coolant
Preparation Steps
Before starting the installation, it’s crucial to prepare your workspace and gather all necessary tools and materials. Ensure that your vehicle is parked on a flat surface and that you have adequate lighting.
1. Disconnect the Battery
Begin by disconnecting the negative terminal of the battery. This step is essential to prevent any electrical shorts during the installation process.
2. Remove the Engine Cover
Next, remove the engine cover to gain access to the turbocharger. This may involve unscrewing several bolts or clips, depending on your specific model.
Removing the Stock Turbocharger
With the engine cover removed, you can now proceed to take out the stock turbocharger. Follow these steps carefully to avoid damaging any components.
1. Disconnect the Exhaust and Intake Lines
Start by disconnecting the exhaust and intake lines connected to the stock turbocharger. Use the appropriate size sockets and wrenches to carefully remove these components.
2. Detach the Oil and Coolant Lines
Next, detach the oil and coolant lines from the stock turbo. Be prepared for some fluid spillage, so have a container ready to catch any leaks.
3. Remove the Turbocharger
Finally, unbolt the turbocharger from its mounting points and carefully remove it from the engine bay. Ensure that you keep track of all bolts and components for reinstallation.
Installing the Garrett GTW2860R Turbo
With the stock turbo removed, it’s time to install the new Garrett GTW2860R turbocharger. Follow these steps to ensure a proper installation.
1. Prepare the New Turbo
Before installation, make sure to check the new turbo for any visible defects. It’s also a good idea to apply a small amount of oil to the turbo bearings to ensure proper lubrication during initial startup.
2. Install the Turbocharger
Position the Garrett GTW2860R turbo in place and secure it with the mounting bolts. Be sure to torque the bolts to the manufacturer’s specifications to prevent any leaks or failures.
3. Reconnect the Oil and Coolant Lines
Reconnect the oil and coolant lines to the new turbo. Ensure that all connections are tight and secure to avoid leaks.
4. Attach the Exhaust and Intake Lines
Next, attach the exhaust and intake lines to the new turbocharger. Make sure to use new gaskets where necessary to ensure a proper seal.
Final Steps
After installing the new turbo, there are a few final steps to ensure everything is in working order before starting your vehicle.
1. Double-Check All Connections
Go through all connections and ensure that everything is properly secured. This includes checking bolts, lines, and hoses.
2. Reinstall the Engine Cover
Once you’re satisfied that everything is in place, reinstall the engine cover to protect the components.
3. Reconnect the Battery
Reconnect the negative terminal of the battery and ensure that it is secure.
4. Start the Engine
With everything reconnected, it’s time to start the engine. Allow it to idle for a few minutes and check for any leaks or unusual noises.
Conclusion
Upgrading to the Garrett GTW2860R turbocharger can provide significant performance improvements for your Civic Type R. By following this step-by-step guide, you can ensure a successful installation and enjoy the enhanced driving experience that comes with it.