Table of Contents
Installing a Walbro 255 fuel pump on your Acura Integra Type R can enhance performance and ensure your vehicle runs smoothly. This guide will walk you through the entire process, making it easy for you to complete the installation yourself.
Why Upgrade to a Walbro 255 Fuel Pump?
The Walbro 255 fuel pump is a popular choice among car enthusiasts for several reasons:
- Increased Fuel Flow: The Walbro 255 provides higher fuel flow rates, which is essential for performance modifications.
- Reliability: Known for its durability, this pump can handle the demands of high-performance engines.
- Easy Installation: The installation process is straightforward and can be completed with basic tools.
Tools and Materials Needed
Before you begin the installation, gather the following tools and materials:
- Walbro 255 Fuel Pump
- Fuel Pump Installation Kit
- Socket Set
- Wrench Set
- Wire Cutters/Strippers
- Electrical Tape
- Safety Goggles
- Gloves
Preparation Steps
Before starting the installation, follow these preparation steps:
- Disconnect the Battery: Always disconnect the negative terminal of the battery to prevent electrical shocks.
- Relieve Fuel Pressure: Remove the fuel pump relay and start the engine until it stalls to relieve pressure.
- Work in a Well-Ventilated Area: Ensure you are in a space with good airflow to avoid inhaling fumes.
Step-by-Step Installation Guide
1. Remove the Fuel Tank
The first step is to remove the fuel tank to access the fuel pump:
- Support the fuel tank with a jack or stand.
- Remove the bolts securing the tank to the chassis.
- Disconnect the fuel lines and electrical connectors.
- Carefully lower the tank and set it aside.
2. Access the Fuel Pump
Once the tank is removed, locate the fuel pump assembly:
- Remove the retaining ring that holds the pump in place.
- Carefully lift the fuel pump assembly out of the tank.
- Disconnect the wiring harness and fuel lines from the pump.
3. Install the Walbro 255 Fuel Pump
Now it’s time to install the new Walbro 255 pump:
- Attach the fuel pump to the assembly, ensuring it fits snugly.
- Reconnect the wiring harness and secure it with electrical tape.
- Reattach the fuel lines to the pump, making sure they are tight.
4. Reassemble the Fuel Tank
With the new pump installed, it’s time to reassemble the fuel tank:
- Carefully lower the fuel pump assembly back into the tank.
- Secure the assembly with the retaining ring.
- Reinstall the fuel tank, reconnecting the fuel lines and electrical connectors.
- Secure the tank with bolts.
5. Final Checks
Before starting your vehicle, perform these final checks:
- Reconnect the battery terminals.
- Check for any fuel leaks around the pump and lines.
- Ensure all connections are secure.
Testing the Installation
After completing the installation, it’s time to test the new fuel pump:
- Turn the ignition key to the “on” position without starting the engine to prime the fuel system.
- Listen for the fuel pump to activate and check for leaks.
- Start the engine and monitor its performance.
Conclusion
Installing a Walbro 255 fuel pump on your Acura Integra Type R is a rewarding project that can significantly improve your vehicle’s performance. By following this guide, you can ensure a successful installation and enjoy the benefits of enhanced fuel delivery.