Table of Contents
The Honda S2000 is a beloved sports car known for its high-revving engine and agile handling. One popular modification among enthusiasts is the installation of a cold air intake system, such as the AEM Cold Air Intake. This modification can lead to noticeable performance gains, including an increase of up to 10 horsepower. In this comprehensive guide, we will walk you through the steps to install the AEM Cold Air Intake on your Honda S2000.
What You Will Need
- AEM Cold Air Intake Kit
- Socket set
- Torque wrench
- Flathead screwdriver
- Phillips screwdriver
- Rubber gloves
- Safety glasses
Before starting the installation process, ensure you have all the necessary tools and equipment. This will make the installation smoother and more efficient.
Preparation Steps
Before you begin the installation, it’s important to prepare your workspace and vehicle. Follow these steps:
- Park your Honda S2000 on a flat surface and engage the parking brake.
- Disconnect the negative battery terminal to prevent any electrical issues.
- Allow the engine to cool down if it has been running.
Removing the Stock Air Intake
The first major step in the installation process is removing the stock air intake system. Here’s how to do it:
- Locate the air intake system on your Honda S2000.
- Using a socket set, remove the bolts securing the airbox.
- Disconnect the mass airflow sensor (MAF) connector by pressing down on the tab and pulling it out.
- Remove the intake hose clamps using a flathead screwdriver and take off the intake hose.
- Carefully lift out the airbox and filter assembly from the engine bay.
Once you have removed the stock air intake, you can proceed to install the AEM Cold Air Intake.
Installing the AEM Cold Air Intake
Now that the stock intake is out, it’s time to install the AEM Cold Air Intake. Follow these steps carefully:
- Start by placing the AEM intake tube into the engine bay, aligning it with the throttle body.
- Secure the intake tube using the provided hose clamps.
- Attach the rubber grommet to the intake tube for the MAF sensor.
- Install the MAF sensor into the grommet, ensuring it is seated properly.
- Reconnect the MAF sensor connector.
- Attach the AEM air filter to the end of the intake tube and secure it with a hose clamp.
- Ensure all connections are tight and secure.
After completing the installation, double-check that everything is in place and secured before moving on.
Final Checks and Reconnecting the Battery
Before starting your engine, it’s important to perform a few final checks:
- Inspect all connections and ensure there are no loose parts.
- Check that the air filter is securely attached.
- Recheck the MAF sensor connection.
Once you are confident everything is installed correctly, reconnect the negative battery terminal.
Testing Your New AEM Cold Air Intake
With the installation complete, it’s time to test your Honda S2000:
- Start the engine and let it idle for a few minutes.
- Listen for any unusual sounds that may indicate a problem.
- Take the car for a test drive to feel the performance difference.
During your test drive, you should notice improved throttle response and potentially increased horsepower. Enjoy the enhanced performance of your Honda S2000!
Conclusion
Installing the AEM Cold Air Intake on your Honda S2000 is a rewarding modification that can lead to significant performance gains. By following this comprehensive guide, you can enhance your driving experience and enjoy the benefits of increased horsepower. Always remember to perform regular maintenance on your vehicle to keep it running smoothly.