Cts Turbo Downpipe Install: Unlock 20-30 Hp on Your S5 3.0t with Expert Steps

by

The CTS Turbo downpipe installation is an excellent modification for the Audi S5 3.0T, promising to unlock an additional 20-30 horsepower. This guide will walk you through the expert steps necessary for a successful installation, ensuring that you can enjoy the enhanced performance of your vehicle.

Tools and Materials Needed

  • CTS Turbo Downpipe
  • Socket set (including 10mm, 13mm, and 15mm sockets)
  • Torque wrench
  • Ratchet
  • Extension bars
  • Flathead screwdriver
  • Phillips screwdriver
  • Jack and jack stands
  • Safety goggles
  • Gloves

Before starting the installation, ensure you have all the necessary tools and materials ready. Having everything on hand will streamline the process and prevent any unnecessary delays.

Preparation Steps

Before diving into the installation, it’s crucial to prepare your workspace and vehicle properly. Follow these preparation steps:

  • Park the vehicle on a flat surface and engage the parking brake.
  • Disconnect the negative battery terminal to prevent any electrical issues.
  • Raise the front of the vehicle using a jack and secure it with jack stands.

Removing the Stock Downpipe

With your vehicle prepared, it’s time to remove the stock downpipe. Follow these steps carefully:

  • Locate the stock downpipe under the vehicle.
  • Remove the heat shield if applicable by unscrewing the bolts.
  • Disconnect the O2 sensor wiring harness from the stock downpipe.
  • Loosen the clamps securing the downpipe to the turbo and exhaust system.
  • Remove the bolts holding the downpipe to the turbo using a socket wrench.
  • Carefully pull the downpipe away from the turbo and exhaust system.

Once the stock downpipe is removed, inspect the area for any debris or damage before proceeding to the installation of the new downpipe.

Installing the CTS Turbo Downpipe

Now that the stock downpipe is out, it’s time to install the CTS Turbo downpipe. Follow these steps:

  • Align the CTS Turbo downpipe with the turbo and exhaust system.
  • Secure the downpipe to the turbo using the provided bolts, ensuring a snug fit.
  • Tighten the clamps connecting the downpipe to the exhaust system.
  • Reconnect the O2 sensor wiring harness to the new downpipe.
  • If applicable, reattach the heat shield using the original bolts.

Make sure everything is tightened to the manufacturer’s specifications to prevent any leaks or issues post-installation.

Final Steps and Testing

After the installation is complete, you will need to perform a few final steps before taking your vehicle for a test drive:

  • Reconnect the negative battery terminal.
  • Start the engine and let it idle for a few minutes to check for any exhaust leaks.
  • Inspect all connections and fittings to ensure they are secure.
  • Take the car for a test drive, paying attention to any unusual noises or performance issues.

After the test drive, if everything is functioning correctly, you can enjoy the enhanced performance of your Audi S5 3.0T with the new CTS Turbo downpipe.

Conclusion

The installation of the CTS Turbo downpipe is a straightforward process that can significantly enhance the performance of your Audi S5 3.0T. By following these expert steps, you can unlock the additional horsepower and enjoy a more exhilarating driving experience.