Diy Clutch Installation: Step-by-step Guide for a 2015 Subaru Wrx with a Clutchnet Stage 2 Kit

by

Installing a new clutch can seem daunting, but with the right tools and guidance, it can be a rewarding DIY project. This guide will walk you through the process of installing a ClutchNet Stage 2 Kit in a 2015 Subaru WRX. By following these steps, you can ensure a smooth installation and enjoy the benefits of enhanced performance.

Tools and Materials Needed

  • ClutchNet Stage 2 Kit
  • Floor jack and jack stands
  • Socket set (including 10mm, 12mm, 14mm, and 17mm sockets)
  • Torque wrench
  • Clutch alignment tool
  • Breaker bar
  • Transmission fluid
  • Shop towels
  • Safety glasses and gloves

Preparation Steps

Before beginning the installation, it’s important to prepare your workspace and the vehicle. Follow these steps:

  • Ensure the vehicle is parked on a flat surface.
  • Disconnect the negative battery terminal to prevent any electrical issues.
  • Raise the front of the vehicle using a floor jack and secure it with jack stands.
  • Remove the front wheels for easier access to the transmission.

Removing the Old Clutch

With the vehicle prepared, you can now begin the removal of the old clutch. Follow these steps carefully:

  • Remove the drive shaft by unbolting it from the rear differential and sliding it out of the transmission.
  • Unbolt the transmission from the engine; this may require removing various components such as the exhaust and heat shields.
  • Support the transmission with a jack and carefully lower it from the engine bay.
  • Once the transmission is out, remove the old clutch assembly by unbolting it from the flywheel.
  • Inspect the flywheel for any damage; if necessary, resurface or replace it before proceeding.

Installing the ClutchNet Stage 2 Kit

Now that the old clutch is removed, it’s time to install the new ClutchNet Stage 2 Kit. Follow these steps:

  • Use the clutch alignment tool to position the new clutch disc onto the flywheel.
  • Secure the new pressure plate onto the flywheel with the provided bolts, tightening them in a crisscross pattern to ensure even pressure.
  • Double-check the alignment of the clutch disc before removing the alignment tool.
  • Reinstall the transmission by carefully raising it into place and bolting it back to the engine.
  • Reconnect the drive shaft, ensuring all bolts are tightened to the manufacturer’s specifications.

Final Steps

With the new clutch installed, it’s time to put everything back together and ensure the vehicle is ready for use:

  • Reconnect any components that were removed, such as the exhaust and heat shields.
  • Reinstall the front wheels and lower the vehicle from the jack stands.
  • Reconnect the negative battery terminal.
  • Fill the transmission with the appropriate fluid if needed.
  • Start the vehicle and test the clutch operation by engaging and disengaging the gears.

Conclusion

Installing a ClutchNet Stage 2 Kit in a 2015 Subaru WRX is a manageable DIY project that can enhance your vehicle’s performance. By following this step-by-step guide, you can successfully complete the installation and enjoy the benefits of a new clutch. Always remember to take your time and ensure each step is completed correctly for the best results.