Diy Guide: Installing a Psa Lightweight Flywheel on Your Hyundai Veloster N

by

Installing a PSA lightweight flywheel on your Hyundai Veloster N can enhance performance and improve throttle response. This DIY guide will walk you through the steps required to successfully complete this installation.

Tools and Materials Needed

  • PSA Lightweight Flywheel
  • Torque wrench
  • Socket set
  • Ratchet
  • Jack and jack stands
  • Flywheel locking tool
  • Engine oil
  • Safety glasses
  • Gloves

Preparation Steps

Before starting the installation, ensure you have all the necessary tools and materials ready. Make sure your vehicle is parked on a flat surface and that the engine is cool.

Safety Precautions

Always wear safety glasses and gloves while working on your vehicle. Ensure the car is securely lifted and supported by jack stands before getting underneath it.

Removing the Old Flywheel

To begin the installation, you need to remove the old flywheel from your Hyundai Veloster N. Follow these steps:

  • Disconnect the negative battery terminal to prevent any electrical issues.
  • Remove the transmission by unbolting the necessary components.
  • Once the transmission is removed, locate the old flywheel.
  • Use the flywheel locking tool to prevent the flywheel from rotating.
  • Unbolt the old flywheel using the socket set and ratchet.
  • Carefully remove the flywheel from the crankshaft.

Installing the PSA Lightweight Flywheel

With the old flywheel removed, you can now install the PSA lightweight flywheel. Follow these steps:

  • Clean the crankshaft surface to ensure a proper fit.
  • Place the new flywheel onto the crankshaft, aligning it correctly.
  • Hand-tighten the bolts to hold the flywheel in place.
  • Use the torque wrench to tighten the flywheel bolts to the manufacturer’s specifications.
  • Remove the flywheel locking tool.

Reassembling the Transmission

After installing the new flywheel, it’s time to reassemble the transmission. Follow these steps:

  • Carefully position the transmission back onto the engine.
  • Reconnect all bolts and components that were removed during disassembly.
  • Ensure all electrical connections are reattached.
  • Reconnect the negative battery terminal.

Final Checks and Testing

Once everything is reassembled, perform the following checks before taking your vehicle for a test drive:

  • Check for any loose bolts or connections.
  • Inspect the area for any fluid leaks.
  • Start the engine and listen for any unusual noises.
  • Take the car for a short test drive to ensure everything is functioning properly.

Conclusion

Installing a PSA lightweight flywheel on your Hyundai Veloster N can significantly enhance your driving experience. By following this DIY guide, you can successfully complete the installation and enjoy improved performance.