Diy Guide: Installing a Tein Coilover Kit on Your New Integra Type S for Improved Ride and Power

by

Installing a Tein Coilover Kit on your new Integra Type S can significantly enhance both ride quality and handling performance. This DIY guide will walk you through the steps necessary to successfully install the coilover kit, allowing you to enjoy better control and improved aesthetics.

What You Will Need

  • Tein Coilover Kit
  • Jack and jack stands
  • Socket wrench set
  • Torque wrench
  • Spring compressors
  • Flathead and Phillips screwdrivers
  • Pliers
  • Safety goggles and gloves

Preparation Steps

Before starting the installation, ensure you have a clean and spacious workspace. Gather all necessary tools and materials. It’s also wise to read the Tein installation manual thoroughly to familiarize yourself with the specific components and procedures.

Safety First

Always wear safety goggles and gloves while working on your vehicle. Make sure the car is parked on a flat surface, and engage the parking brake before starting the installation.

Removing the Stock Suspension

To begin the installation, you will need to remove the stock suspension components. Follow these steps carefully:

  • Use the jack to lift the front of the car and secure it with jack stands.
  • Remove the front wheels using a socket wrench.
  • Locate the strut assembly and disconnect any electrical connectors if applicable.
  • Remove the bolts securing the strut to the steering knuckle.
  • Unbolt the top strut mount from the engine bay.
  • Carefully remove the strut assembly from the vehicle.
  • Repeat the process for the rear suspension.

Preparing the Tein Coilover Kit

Once the stock suspension is removed, it’s time to prepare the Tein Coilover Kit for installation. This involves adjusting the coilovers to your desired height and settings.

  • Use the spring compressors to compress the coil springs on the Tein coilovers.
  • Adjust the height settings according to your preference.
  • Ensure all locking collars are tightened securely.
  • Double-check that the damping settings are set to your desired level.

Installing the Tein Coilover Kit

With the coilovers prepared, you can now install them into your Integra Type S. Follow these steps for both the front and rear coilovers:

  • Position the coilover into the strut tower and secure it with the top mount bolts.
  • Reattach the strut to the steering knuckle using the previously removed bolts.
  • Ensure all connections are tight and secure.
  • Repeat the installation process for the rear coilovers.

Final Adjustments and Checks

After installing the coilovers, it’s essential to make final adjustments and checks to ensure everything is in order:

  • Lower the vehicle and remove the jack stands.
  • Check the ride height and adjust if necessary.
  • Torque all bolts to the manufacturer’s specifications.
  • Perform a visual inspection to ensure everything is properly installed.

Test Drive and Enjoy

Once all checks are complete, take your Integra Type S for a test drive. Pay attention to the ride quality and handling. Make further adjustments if needed to achieve your desired performance.

Conclusion

Installing a Tein Coilover Kit on your Integra Type S can transform your driving experience. With improved handling and ride quality, you’ll enjoy a more engaging and responsive vehicle. Remember to perform regular maintenance checks to keep your suspension in top shape.