Table of Contents
Installing a Meltek Cold Air Intake on a 2.0 TFSI engine can enhance performance and improve engine efficiency. This guide provides a step-by-step process along with a cost breakdown to help you with your DIY installation.
Tools and Materials Needed
- Meltek Cold Air Intake Kit
- Socket set
- Wrenches
- Screwdrivers (flathead and Phillips)
- Torque wrench
- Air filter cleaner
- Shop towels
- Safety glasses
Preparation Steps
Before starting the installation, ensure you have all the necessary tools and materials. It’s also important to work in a well-ventilated area and wear safety glasses to protect your eyes.
Step 1: Gather Your Tools
Collect all tools and the Meltek Cold Air Intake kit. Check the kit to ensure all components are included.
Step 2: Disconnect the Battery
For safety, disconnect the negative terminal of the battery to prevent any electrical issues during installation.
Removing the Stock Air Intake
Before installing the new cold air intake, you need to remove the stock air intake system. Follow these steps:
Step 3: Remove the Engine Cover
Use your socket set to remove the bolts securing the engine cover. Carefully lift it off and set it aside.
Step 4: Disconnect the Air Intake Hose
Loosen the clamps on the air intake hose using a screwdriver. Gently pull the hose off the throttle body.
Step 5: Remove the Stock Air Box
Unbolt the stock air box from its mounting points. Carefully lift it out, ensuring no components are damaged.
Installing the Meltek Cold Air Intake
Now that the stock intake is removed, it’s time to install the Meltek Cold Air Intake. Follow these steps:
Step 6: Position the New Air Intake
Align the new air intake system with the throttle body. Ensure the mounting points match up properly.
Step 7: Secure the Air Intake
Use the provided bolts and a torque wrench to secure the air intake in place. Follow the manufacturer’s specifications for torque settings.
Step 8: Connect the Air Intake Hose
Slide the air intake hose onto the throttle body and tighten the clamps securely.
Step 9: Reinstall the Engine Cover
Place the engine cover back onto its mounting points and secure it with the bolts you removed earlier.
Final Steps
After installation, it’s important to check everything before starting the engine.
Step 10: Reconnect the Battery
Reconnect the negative terminal of the battery, ensuring it is tight and secure.
Step 11: Start the Engine
Start the engine and listen for any unusual sounds. Ensure the intake is functioning properly.
Cost Breakdown
Understanding the costs involved can help you budget for the installation. Here’s a breakdown:
- Meltek Cold Air Intake Kit: $250
- Tools (if not already owned): $100
- Miscellaneous Supplies (cleaners, towels): $20
- Total Estimated Cost: $370
Conclusion
Installing the Meltek Cold Air Intake on a 2.0 TFSI engine is a straightforward DIY project that can yield significant performance benefits. With the right tools and careful attention to detail, you can enhance your vehicle’s performance while saving on installation costs.