Diy Q50 Red Sport Mods: Installing a Stillen Cold Air Intake in 2 Hours

by

The Infiniti Q50 Red Sport is a performance-oriented sedan that offers a thrilling driving experience. One of the most effective modifications you can make to enhance its performance is installing a Stillen Cold Air Intake. This modification not only improves airflow to the engine but also increases horsepower and torque. In this article, we will guide you through the process of installing a Stillen Cold Air Intake in approximately two hours.

Tools and Materials Needed

  • Stillen Cold Air Intake Kit
  • Socket wrench set
  • Flathead screwdriver
  • Phillips screwdriver
  • Torque wrench
  • Rubber gloves
  • Safety glasses
  • Shop towels

Preparation Steps

Before starting the installation process, it’s essential to prepare your workspace and gather all the necessary tools and materials. Follow these steps:

  • Park your vehicle on a flat surface and engage the parking brake.
  • Allow the engine to cool down completely to prevent burns.
  • Disconnect the negative battery terminal to ensure safety.

Removing the Stock Air Intake System

The first step in the installation process is to remove the stock air intake system. Follow these steps carefully:

  • Locate the air intake assembly on the driver’s side of the engine bay.
  • Using a socket wrench, remove the bolts securing the air intake to the engine.
  • Disconnect the mass air flow (MAF) sensor connector by pressing the tab and pulling it out.
  • Loosen the hose clamps on the intake tube using a flathead screwdriver.
  • Carefully pull the intake tube away from the throttle body and remove the entire air intake assembly.

Installing the Stillen Cold Air Intake

Now that the stock air intake system is removed, you can proceed to install the Stillen Cold Air Intake. Follow these steps:

  • Begin by placing the new Stillen air intake tubes into position.
  • Secure the intake tubes to the throttle body using the provided hose clamps.
  • Reconnect the MAF sensor connector to the new intake tube.
  • Install the air filters onto the ends of the intake tubes, ensuring they are secured tightly.
  • Double-check all connections and ensure everything is properly aligned.

Finalizing the Installation

With the Stillen Cold Air Intake installed, it’s time to finalize the process:

  • Reconnect the negative battery terminal that you previously disconnected.
  • Start the engine and check for any unusual noises or leaks.
  • Allow the engine to idle for a few minutes to ensure everything is functioning correctly.
  • Take your Q50 for a test drive to experience the enhanced performance.

Conclusion

Installing a Stillen Cold Air Intake on your Infiniti Q50 Red Sport is a straightforward process that can be completed in about two hours. Not only does this modification improve engine performance, but it also enhances the overall driving experience. With the right tools and careful attention to detail, you can enjoy the benefits of increased horsepower and torque in no time.