Table of Contents
The Dodge Durango Hellcat is a powerful SUV that offers impressive performance right off the factory floor. However, for those looking to enhance its capabilities even further, the Hennessey HPE1000 Supercharger Kit is a popular modification. This article provides a step-by-step installation guide for this supercharger kit, allowing you to unleash even more horsepower from your Durango Hellcat.
What You Will Need
- Hennessey HPE1000 Supercharger Kit
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Ratchet and extensions
- Coolant and oil (for refilling)
- Safety glasses and gloves
Preparation
Before starting the installation, ensure you have a clean workspace and all the necessary tools and components ready. It’s important to work in a well-ventilated area and to wear safety equipment to protect yourself during the process.
Step 1: Disconnect the Battery
Begin by disconnecting the negative terminal of the battery to prevent any electrical issues during the installation. This step is crucial for your safety and the integrity of the vehicle’s electrical system.
Step 2: Remove the Engine Cover
Next, remove the engine cover by unscrewing the bolts holding it in place. Carefully set the cover aside to expose the engine components beneath.
Step 3: Remove the Stock Supercharger
To install the Hennessey supercharger, you must first remove the stock supercharger. Start by disconnecting the intake tubing and any electrical connectors attached to the supercharger. Then, unbolt it from the engine and lift it out carefully.
Step 4: Install the Hennessey HPE1000 Supercharger
Now it’s time to install the new Hennessey supercharger. Position it in place and secure it with the provided bolts. Make sure to follow the torque specifications outlined in the installation manual for proper fitment.
Step 5: Reconnect the Intake Tubing
After securing the supercharger, reconnect the intake tubing and any electrical connectors that were previously removed. Double-check all connections to ensure they are secure and properly seated.
Step 6: Reinstall the Engine Cover
Once everything is connected, reinstall the engine cover by securing it with the bolts you removed earlier. This will protect the engine components and give your Durango a clean look.
Step 7: Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure that the connection is tight to avoid any electrical issues.
Step 8: Start the Engine
With everything reassembled, start the engine and listen for any unusual noises. Allow the engine to idle for a few minutes, checking for leaks or issues. If everything sounds normal, you’re ready to hit the road!
Step 9: Tune the Engine
After installation, it is essential to tune the engine to optimize performance with the new supercharger. This may involve using a performance tuning tool or visiting a professional tuner to ensure your Durango Hellcat runs at its best.
Final Thoughts
Installing the Hennessey HPE1000 Supercharger Kit on your Dodge Durango Hellcat can significantly enhance its performance and driving experience. By following this step-by-step guide, you can ensure a successful installation and enjoy the added power that comes with it. Always remember to drive responsibly and enjoy your upgraded SUV!