Table of Contents
The installation of an ETS Motorsport Golf R downpipe is a popular modification among enthusiasts looking to enhance their vehicle’s performance. This step-by-step guide will walk you through the installation process, ensuring you maximize the benefits of your new downpipe.
What You Will Need
- ETS Motorsport Golf R Downpipe
- Socket wrench set
- Torque wrench
- Jack and jack stands
- Safety glasses
- Gloves
- Exhaust gasket
- High-temperature exhaust sealant (optional)
Before starting the installation, ensure you have all the necessary tools and parts. Working on your vehicle can be dangerous, so always prioritize safety.
Preparation
Begin by parking your Golf R on a flat surface. Engage the parking brake and allow the engine to cool completely. This is essential to prevent burns and ensure safe handling of components.
Next, raise the car using a jack and secure it with jack stands. Make sure the vehicle is stable before proceeding.
Removing the Stock Downpipe
The first step in the installation process is to remove the stock downpipe. Follow these steps:
- Locate the downpipe under the vehicle.
- Disconnect the oxygen sensor wiring harness by gently pulling it apart.
- Unbolt the downpipe from the turbocharger using a socket wrench.
- Remove any additional bolts securing the downpipe to the exhaust system.
- Carefully slide the downpipe out of its position.
Be cautious during this step, as some bolts may be rusted or difficult to reach. Applying penetrating oil can help loosen stubborn bolts.
Installing the ETS Downpipe
Once the stock downpipe is removed, it’s time to install the ETS Motorsport downpipe. Follow these steps:
- Position the ETS downpipe in place, ensuring it aligns with the turbocharger.
- Use the new exhaust gasket to seal the connection between the downpipe and the turbocharger.
- Hand-tighten the bolts to hold the downpipe in position.
- Once secure, use a torque wrench to tighten the bolts to the manufacturer’s specifications.
- Reconnect the oxygen sensor wiring harness to the new downpipe.
Ensure that all connections are tight and there are no leaks. If using high-temperature exhaust sealant, apply it to the joints for added security.
Final Steps
After the downpipe is installed, it’s crucial to recheck all connections and components. Follow these steps:
- Inspect the area around the downpipe for any signs of leaks.
- Check that all bolts are tightened to the specified torque.
- Lower the vehicle back to the ground carefully.
- Start the engine and allow it to idle for a few minutes.
- Listen for any unusual noises or leaks during the idle.
If everything sounds and looks good, take your Golf R for a test drive. Pay attention to the performance improvements and ensure there are no warning lights on the dashboard.
Benefits of Upgrading to an ETS Downpipe
Upgrading to an ETS Motorsport downpipe offers several advantages for your Golf R:
- Increased horsepower: The downpipe reduces back pressure, allowing for better exhaust flow and increased power.
- Improved throttle response: Enhanced exhaust flow leads to quicker throttle response, making the vehicle more enjoyable to drive.
- Better sound: The downpipe can provide a deeper, more aggressive exhaust note.
- Weight reduction: Aftermarket downpipes are often lighter than stock components, improving overall vehicle dynamics.
These benefits make the ETS Motorsport downpipe a worthy investment for any Golf R enthusiast looking to enhance their vehicle’s performance.
Conclusion
Installing an ETS Motorsport Golf R downpipe is a straightforward process that can significantly improve your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of your new downpipe. Always remember to prioritize safety and consult a professional if you’re unsure about any steps in the process.