Table of Contents
Installing a boost tap is an essential modification for B8 A4 2.0T owners looking to enhance their vehicle’s performance. This guide will walk you through the process step-by-step to ensure a successful installation.
What You Will Need
- Forge Motorsport Boost Tap Kit
- Socket set
- Wrenches
- Torque wrench
- Vacuum line (if not included in the kit)
- Rags for cleanup
- Safety glasses
Preparation
Before starting the installation, ensure your vehicle is parked on a flat surface. Turn off the engine and allow it to cool down. Wear safety glasses to protect your eyes during the process.
Step 1: Remove Engine Cover
Using your socket set, carefully remove the bolts securing the engine cover. Set the cover aside in a safe location.
Step 2: Locate the Boost Pressure Sensor
The boost pressure sensor is located on the intake manifold. Identify its position as you will need to disconnect it for the installation.
Step 3: Disconnect the Boost Pressure Sensor
Gently disconnect the electrical connector from the boost pressure sensor. Be cautious not to damage the connector or the sensor itself.
Step 4: Remove the Boost Pressure Sensor
Using the appropriate socket, remove the boost pressure sensor from the intake manifold. Make sure to keep any O-rings or seals that may come with it.
Step 5: Install the Forge Boost Tap
Take the Forge Motorsport boost tap and install it into the intake manifold where the boost pressure sensor was previously located. Ensure it is seated properly and secure it with the provided hardware.
Step 6: Reconnect the Boost Pressure Sensor
Reconnect the boost pressure sensor to the boost tap. Ensure the connection is firm and secure to prevent any leaks.
Step 7: Reinstall the Engine Cover
Once everything is connected, carefully place the engine cover back onto the engine. Secure it with the bolts you removed earlier.
Final Steps
After the installation is complete, it’s important to check for any leaks. Start the engine and let it idle for a few minutes while you inspect the area around the boost tap and sensor.
Step 8: Check for Leaks
Look for any signs of air leaks around the boost tap and connections. If you notice any leaks, turn off the engine and recheck all connections.
Conclusion
The installation of the Forge Motorsport boost tap can enhance the performance of your B8 A4 2.0T. By following these steps carefully, you can ensure a successful installation and enjoy the benefits of improved boost monitoring.