Table of Contents
Upgrading the fuel system in your Subaru WRX can significantly enhance performance, especially if you’re planning on increasing horsepower. One of the most effective upgrades is the installation of a FuelLab Boost-A-Pump. This guide will walk you through the costs and steps involved in installing this component for under $500.
Understanding the FuelLab Boost-A-Pump
The FuelLab Boost-A-Pump is designed to increase fuel flow under high demand conditions. It works by boosting the voltage to the fuel pump, allowing it to deliver more fuel when needed. This is particularly beneficial for WRX owners looking to support higher horsepower levels.
Cost Breakdown for Installation
When considering the installation of a FuelLab Boost-A-Pump, it’s essential to break down the costs involved. Below is a detailed list of potential expenses:
- FuelLab Boost-A-Pump Kit: $300
- Installation Kit (wiring, connectors): $50
- Labor (if not DIY): $100
- Miscellaneous (tools, fluids): $50
In total, the estimated cost for installing a FuelLab Boost-A-Pump on your Subaru WRX can be kept under $500, especially if you choose to do the installation yourself.
Tools Required for Installation
Before you start the installation, ensure you have the following tools:
- Socket set
- Wrenches
- Wire strippers and crimpers
- Multimeter
- Heat shrink tubing
- Electrical tape
Step-by-Step Installation Guide
1. Preparation
Start by disconnecting the battery to prevent any electrical shorts. Then, relieve the fuel system pressure by removing the fuel pump fuse and starting the engine until it stalls.
2. Accessing the Fuel Pump
Remove the rear seat cushion to access the fuel pump access panel. Unscrew the panel and disconnect the fuel lines and electrical connectors from the existing fuel pump.
3. Installing the Boost-A-Pump
Follow the instructions provided with the FuelLab Boost-A-Pump kit. Typically, you’ll need to mount the pump, connect the wiring harness, and ensure all connections are secure. Make sure to use heat shrink tubing and electrical tape to protect your connections.
4. Reassembling the Fuel System
Once the Boost-A-Pump is installed, reconnect the fuel lines and electrical connectors. Replace the access panel and rear seat cushion. Reinstall the fuel pump fuse.
5. Testing
Reconnect the battery and turn the ignition to the “ON” position without starting the engine. This will prime the fuel system. Check for any leaks around the fuel lines and connections. If everything looks good, start the engine and monitor its performance.
Benefits of Upgrading Your Fuel System
Installing a FuelLab Boost-A-Pump offers several advantages:
- Increased fuel flow for higher horsepower applications.
- Improved throttle response.
- Enhanced engine performance and efficiency.
- Cost-effective upgrade for performance enthusiasts.
Conclusion
Upgrading the fuel system in your Subaru WRX with a FuelLab Boost-A-Pump is a smart investment for those looking to enhance their vehicle’s performance. With careful planning and execution, you can complete the installation for under $500, unlocking the potential for greater power and efficiency.