Gt-r Turbo Upgrade Installation Guide: Installing the Tial Q Series 700hp Kit

by

The Nissan GT-R is renowned for its performance and tuning potential. Upgrading the turbo system is one of the most effective ways to enhance power output. This guide focuses on installing the Tial Q Series 700hp turbo kit, a popular choice among enthusiasts aiming for serious horsepower gains.

Tools and Materials Needed

  • Socket set (metric)
  • Torque wrench
  • Flathead screwdriver
  • Phillips screwdriver
  • Wrenches (metric)
  • Intercooler piping
  • Oil feed and drain lines
  • Gaskets and seals
  • Tial Q Series turbo kit
  • Boost controller
  • Coolant
  • Engine oil

Preparation Steps

Before beginning the installation, ensure the vehicle is parked on a flat surface and the engine is cool. Disconnect the battery to prevent any electrical issues during the installation process.

Remove the Existing Turbo Setup

Start by removing the stock turbocharger and associated components. Follow these steps:

  • Remove the intake piping connected to the stock turbo.
  • Disconnect the oil feed and drain lines.
  • Unbolt the turbo from the manifold.
  • Remove any heat shields or brackets obstructing access.
  • Carefully take out the turbocharger from the engine bay.

Installing the Tial Q Series Turbo

With the old turbo removed, it’s time to install the new Tial Q Series turbo. Follow these steps:

  • Place the new turbo on the manifold and align it with the mounting holes.
  • Secure the turbo using the provided bolts. Tighten them to the manufacturer’s specifications.
  • Reconnect the oil feed and drain lines, ensuring there are no leaks.
  • Install the new gaskets to prevent any exhaust leaks.
  • Attach the intake piping to the turbo. Ensure all clamps are tight.

Boost Controller Installation

The boost controller is crucial for managing the new turbo’s performance. Follow these steps to install it:

  • Locate a suitable position for the boost controller inside the cabin.
  • Run the necessary wiring from the boost controller to the engine bay.
  • Connect the boost controller to the wastegate and vacuum source.
  • Ensure all connections are secure and free from leaks.

Final Checks and Testing

Once the installation is complete, perform the following checks before starting the engine:

  • Double-check all connections and bolts for tightness.
  • Ensure there are no oil or coolant leaks.
  • Reconnect the battery.
  • Start the engine and allow it to idle. Monitor for any unusual sounds or leaks.
  • Once the engine is warm, perform a test drive to assess performance.

Conclusion

Installing the Tial Q Series 700hp turbo kit on your Nissan GT-R can significantly enhance its performance. With careful preparation and attention to detail, you can successfully upgrade your turbo system and enjoy the increased power and responsiveness.