Table of Contents
Upgrading your vehicle’s handling is crucial for improving track performance. One of the most effective modifications you can make is installing Miller Motorsport Coilovers. This guide will walk you through the steps to install these coilovers, ensuring that your car handles better on the track.
Why Upgrade to Coilovers?
Coilovers offer several advantages over traditional suspension systems:
- Adjustability: Coilovers allow you to adjust ride height and damping settings for optimal performance.
- Improved Handling: Lowering your car’s center of gravity enhances stability and cornering ability.
- Customization: You can tailor your suspension setup to fit your specific driving style and track conditions.
Tools and Materials Needed
Before you begin the installation process, gather the following tools and materials:
- Socket set
- Wrench set
- Torque wrench
- Spring compressor
- Jack and jack stands
- Coilover kit from Miller Motorsport
- Lubricant or anti-seize compound
Installation Steps
Step 1: Prepare Your Vehicle
Start by parking your vehicle on a flat surface and engaging the parking brake. Loosen the lug nuts on the wheels you will be working on but do not remove them yet.
Step 2: Lift the Vehicle
Use a jack to lift the front or rear of the vehicle, depending on where you are installing the coilovers. Secure the vehicle with jack stands to ensure safety while you work.
Step 3: Remove the Wheels
Now, remove the loosened lug nuts and take off the wheels to expose the suspension components.
Step 4: Remove the Old Suspension
Begin by disconnecting any components that may obstruct the removal of the old strut assembly. This may include:
- Brake lines
- Sway bar links
- Upper strut mounts
Once everything is disconnected, remove the bolts securing the strut assembly to the vehicle and carefully take it out.
Step 5: Prepare the Coilovers
Using a spring compressor, safely compress the springs on the new coilovers if they are not pre-assembled. Apply lubricant to the threads of the coilover adjusters to ensure smooth operation.
Step 6: Install the Coilovers
Position the new coilover assembly into the suspension mounting points. Secure it with the bolts you removed earlier, tightening them to the manufacturer’s specifications using a torque wrench.
Step 7: Reconnect Components
Reconnect all components that were removed, including brake lines and sway bar links. Ensure everything is secured and properly aligned.
Step 8: Adjust Ride Height
Before reinstalling the wheels, adjust the ride height of the coilovers to your desired specification. This can usually be done by turning the adjuster at the bottom of the coilover.
Step 9: Reinstall the Wheels
Place the wheels back onto the hubs and hand-tighten the lug nuts. Lower the vehicle back to the ground and then use a torque wrench to tighten the lug nuts to the specified torque.
Step 10: Final Checks
Check all connections and ensure that everything is secure. Take your vehicle for a test drive to feel the new suspension performance. Make any necessary adjustments to the ride height or damping settings based on your driving experience.
Conclusion
Installing Miller Motorsport Coilovers can significantly enhance your vehicle’s handling on the track. By following this guide, you can ensure a successful installation and enjoy improved performance. Remember to make adjustments as needed to tailor your setup for the best results on the track.