How to Achieve 500+ Hp on a Budget: Installing a Mopar Performance 6-pack Intake and Carb on Your B-body for Under $2,000

by

Achieving 500+ horsepower on a budget can seem daunting, especially for classic car enthusiasts looking to enhance their B-body Mopar. However, with the right components and a bit of know-how, it is possible to install a Mopar Performance 6-pack intake and carb setup for under $2,000. This article will guide you through the process, step by step.

Understanding the Basics

Before diving into the installation process, it’s important to understand the components involved and how they work together to boost horsepower. The Mopar Performance 6-pack system is designed to maximize airflow and fuel delivery, which are critical for achieving higher horsepower numbers.

  • Mopar Performance 6-pack intake manifold
  • Three two-barrel carburetors
  • Proper gaskets and hardware
  • Performance ignition system
  • Exhaust upgrades (headers and mufflers)

Gathering Your Materials

To stay within budget, sourcing your materials wisely is essential. Here’s a list of what you’ll need for the installation:

  • Mopar Performance 6-pack intake manifold
  • Three two-barrel carburetors (preferably Holley or Edelbrock)
  • Intake gaskets
  • Carburetor gaskets
  • Mounting hardware
  • New fuel lines
  • Performance ignition coil and wires
  • Exhaust headers (if necessary)
  • Basic hand tools (wrenches, sockets, screwdrivers)

Preparation Steps

Before you start the installation, ensure your workspace is clean and organized. Follow these preparation steps:

  • Disconnect the battery to prevent electrical shorts.
  • Remove the existing intake manifold and carburetor.
  • Clean the engine block surface thoroughly to ensure a good seal.
  • Inspect all components for wear and replace any damaged parts.

Installing the Mopar Performance 6-Pack Intake

Now that you have everything ready, it’s time to install the intake manifold. Follow these steps carefully:

  • Place the new intake gaskets on the engine block, aligning them properly.
  • Carefully position the Mopar Performance 6-pack intake manifold onto the gaskets.
  • Secure the manifold using the provided mounting hardware, tightening to the manufacturer’s specifications.
  • Ensure that all ports are aligned and sealed properly.

Installing the Carburetors

With the intake manifold securely in place, you can now install the carburetors. Here’s how:

  • Attach the carburetor gaskets to each of the three carburetors.
  • Mount each carburetor onto the intake manifold, ensuring they are snug and secure.
  • Connect the fuel lines to the carburetors, ensuring there are no leaks.
  • Check the float levels and adjust as necessary for optimal performance.

Final Adjustments and Testing

After installation, you need to make some final adjustments to ensure everything runs smoothly:

  • Reconnect the battery and check all electrical connections.
  • Adjust the ignition timing for optimal performance.
  • Start the engine and let it idle, checking for any leaks or unusual sounds.
  • Test drive the vehicle to evaluate the performance and make further adjustments as needed.

Conclusion

Installing a Mopar Performance 6-pack intake and carb setup can significantly enhance your B-body’s horsepower without breaking the bank. With careful planning, sourcing materials wisely, and following the installation steps, you can achieve over 500 horsepower for under $2,000. Enjoy your newly enhanced ride!