Table of Contents
Installing a BMS cold air intake on your BMW 3 Series can significantly enhance your vehicle’s performance. This guide will walk you through the installation process step-by-step and highlight the benefits of upgrading your intake system.
Benefits of a Cold Air Intake
A cold air intake system can provide several performance benefits for your BMW 3 Series, including:
- Increased Horsepower: A cold air intake allows for better airflow, which can lead to increased horsepower.
- Improved Throttle Response: Enhanced airflow can result in quicker throttle response.
- Better Fuel Efficiency: More efficient combustion can lead to improved fuel economy.
- Enhanced Engine Sound: A cold air intake can give your engine a more aggressive sound.
Tools and Materials Needed
Before starting the installation, gather the following tools and materials:
- Socket set
- Screwdriver set
- Torque wrench
- New BMS cold air intake kit
- Shop towels
- Safety gloves
Step-by-Step Installation Guide
Step 1: Prepare Your Vehicle
Begin by parking your BMW 3 Series on a flat surface and turning off the engine. Allow the engine to cool down completely before proceeding.
Step 2: Remove the Factory Air Intake
Open the hood and locate the factory air intake system. Use your socket set to remove any bolts or screws securing the intake. Carefully disconnect any hoses or clamps attached to the intake.
Step 3: Install the BMS Cold Air Intake
Take the BMS cold air intake out of the box and compare it to the factory intake to ensure you have all necessary components. Begin by connecting the new intake to the throttle body, ensuring a secure fit. Use the provided clamps to tighten it in place.
Step 4: Secure the Intake System
Once the intake is connected, secure it using the bolts and screws you removed earlier. Make sure everything is tightened to the manufacturer’s specifications using your torque wrench.
Step 5: Reconnect Any Hoses or Sensors
Reconnect any hoses or sensors that were disconnected during the removal of the factory intake. Double-check all connections to ensure they are secure and properly fitted.
Step 6: Test the Installation
Start your engine and listen for any unusual sounds. Ensure that the engine runs smoothly and that there are no warning lights on the dashboard. Take your BMW for a short drive to test the performance of the new intake.
Conclusion
Installing a BMS cold air intake on your BMW 3 Series is a straightforward process that can lead to noticeable performance improvements. With the right tools and careful attention to detail, you can enhance your vehicle’s efficiency and driving experience.