Table of Contents
Installing a COMP Cams performance camshaft in your RSX Type S can significantly enhance your vehicle’s performance. This guide will walk you through the steps necessary to complete this installation successfully.
Tools and Materials Needed
- COMP Cams performance camshaft
- Socket set
- Torque wrench
- Screwdrivers (flathead and Phillips)
- Camshaft installation tool
- Engine oil
- Gasket maker or new gaskets
- Shop towels
Preparation Steps
Before beginning the installation, ensure that your vehicle is parked on a level surface and the engine is cool. Disconnect the battery to prevent any electrical issues during the process.
Remove Engine Covers
Start by removing any plastic engine covers. Use the appropriate screwdriver or socket to remove the screws or bolts holding the covers in place. Set them aside in a safe location.
Drain Engine Oil
Next, drain the engine oil to avoid any spills during the installation. Place a drain pan under the oil pan and remove the oil drain plug. Allow the oil to fully drain before replacing the plug.
Removing the Old Camshaft
Once the preparation steps are complete, you can begin removing the old camshaft. This process involves several steps to ensure everything is done correctly.
Remove Timing Chain/Belt
To access the camshaft, you will need to remove the timing chain or belt. Refer to your vehicle’s manual for the specific procedure, as it can vary. Generally, you will need to remove the timing cover and loosen the tensioner to release the chain or belt.
Detach the Old Camshaft
With the timing chain or belt removed, locate the camshaft retaining bolts. Use a socket to remove these bolts and carefully lift the old camshaft out of its housing. Be cautious not to damage any surrounding components.
Installing the COMP Cams Performance Camshaft
Now that the old camshaft is removed, it’s time to install the new COMP Cams performance camshaft. Follow these steps to ensure a proper installation.
Prepare the New Camshaft
Before installing the new camshaft, apply a thin layer of engine oil to the camshaft lobes and journals. This helps ensure proper lubrication during the initial start-up.
Install the New Camshaft
Carefully place the new camshaft into the engine block, aligning it with the timing chain or belt. Once in place, secure it using the camshaft retaining bolts. Follow the manufacturer’s torque specifications to ensure a proper fit.
Reassembling the Engine
After the new camshaft is installed, you will need to reassemble the engine components that were removed during the process.
Reattach Timing Chain/Belt
Reinstall the timing chain or belt according to the specifications in your vehicle’s manual. Ensure that the timing marks are aligned correctly to avoid any timing issues.
Replace Engine Covers
Once everything is reattached, replace the engine covers. Secure them with the screws or bolts that were removed earlier.
Final Steps
With the installation complete, there are a few final steps to ensure everything is ready for operation.
Refill Engine Oil
Refill the engine with new oil. Make sure to use the recommended oil type for your RSX Type S. After filling, check the oil level using the dipstick and add more if necessary.
Reconnect the Battery
Reconnect the battery and ensure that all connections are secure. This will allow the engine to start properly.
Start the Engine
Finally, start the engine and listen for any unusual noises. Allow it to idle for a few minutes while checking for leaks. If everything sounds and looks good, take your RSX Type S for a test drive to experience the performance boost.
Conclusion
Installing a COMP Cams performance camshaft in your RSX Type S can lead to improved engine performance and responsiveness. By following these steps carefully, you can ensure a successful installation and enjoy the benefits of your enhanced vehicle.