How to Install a Greddy E-manage Ecu System on Your 2g Eclipse for up to 30 Hp Boost

by

Installing a Greddy E-manage ECU system on your 2G Eclipse can significantly enhance performance, potentially adding up to 30 horsepower. This guide will walk you through the installation process step-by-step, ensuring that you can achieve optimal results safely and effectively.

What You Will Need

  • Greddy E-manage ECU system
  • 2G Eclipse vehicle
  • Basic hand tools (screwdrivers, wrenches, etc.)
  • Wire strippers and connectors
  • Electrical tape
  • OBD-II scanner (optional)

Preparation

Before starting the installation, ensure that your vehicle is parked on a flat surface and the engine is cool. Disconnect the battery to prevent any electrical issues during the installation process.

Removing the Factory ECU

The first step in the installation process is removing the factory ECU. Follow these steps:

  • Locate the factory ECU, which is typically found under the dashboard on the driver’s side.
  • Unscrew any screws or bolts securing the ECU in place.
  • Carefully disconnect the wiring harness from the ECU.
  • Remove the ECU from its mounting location.

Installing the Greddy E-manage ECU

With the factory ECU removed, you can now install the Greddy E-manage ECU. Follow these steps:

  • Position the Greddy E-manage ECU in the same location as the factory ECU.
  • Connect the wiring harness to the Greddy E-manage ECU, ensuring a secure fit.
  • Use the provided screws or bolts to secure the ECU in place.

Wiring the E-manage System

Next, you will need to wire the E-manage system to your vehicle. This is a critical step that requires attention to detail:

  • Refer to the E-manage wiring diagram provided in the installation manual.
  • Strip the ends of the wires that need to be connected.
  • Connect the E-manage wires to the corresponding wires in the vehicle, using connectors.
  • Secure all connections with electrical tape to prevent any short circuits.

Configuring the E-manage System

After the wiring is complete, you will need to configure the E-manage system to work with your engine. This involves:

  • Using the E-manage software on your laptop or computer.
  • Connecting the E-manage unit to your computer using the provided cable.
  • Following the software instructions to set up the system parameters according to your vehicle’s specifications.

Testing the Installation

Once everything is installed and configured, it’s time to test the setup:

  • Reconnect the vehicle’s battery.
  • Start the engine and check for any warning lights on the dashboard.
  • Use an OBD-II scanner to check for any error codes.
  • Take the vehicle for a test drive to ensure that the E-manage system is functioning properly.

Tuning for Performance

After confirming that the installation is successful, you can begin tuning the E-manage system for optimal performance:

  • Adjust fuel maps based on your driving style and needs.
  • Fine-tune ignition timing for better throttle response.
  • Monitor engine performance with a dyno or performance tuning software.

Conclusion

Installing a Greddy E-manage ECU system on your 2G Eclipse can lead to significant performance gains. By following this guide, you should be able to install the system safely and effectively, unlocking up to 30 horsepower. Always remember to take your time and ensure each step is performed correctly for the best results.