Table of Contents
The Nissan Skyline R34 is a legendary vehicle known for its performance and tuning potential. One of the most effective upgrades you can make to enhance its cooling and power is installing a Greddy intercooler. This article will guide you through the installation process step-by-step.
Tools and Materials Needed
- Greddy intercooler kit
- Socket set
- Wrenches
- Flathead screwdriver
- Phillips screwdriver
- Hose clamps
- Silicone couplers
- Torque wrench
- Cooling system cleaner
- Rags and cleaning supplies
Preparation Steps
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Gather all your tools and materials to avoid interruptions during the process.
1. Disconnect the Battery
To prevent any electrical issues, disconnect the negative terminal of the battery. This step is crucial for your safety during the installation.
2. Remove the Front Bumper
Begin by removing the screws and clips that secure the front bumper. Carefully pull the bumper away from the vehicle, ensuring not to damage any wiring or clips connected to it.
3. Drain the Cooling System
Locate the radiator drain plug and place a container underneath to catch the coolant. Open the drain plug and let the coolant flow out completely. This step will help prevent spills during the intercooler installation.
Removing the Stock Intercooler
Now that the front bumper is off, you can access the stock intercooler. Follow these steps to remove it safely.
1. Disconnect the Piping
Using your socket set, loosen and remove the clamps securing the piping to the stock intercooler. Carefully disconnect the piping and set it aside.
2. Unbolt the Intercooler
Locate the bolts securing the stock intercooler to the vehicle. Use your socket wrench to remove these bolts and lift the intercooler out of its mounting location.
Installing the Greddy Intercooler
With the stock intercooler removed, you can now install the Greddy intercooler. Follow the steps below for a successful installation.
1. Position the New Intercooler
Carefully position the Greddy intercooler in the same location as the stock intercooler. Ensure that it fits securely and aligns with the mounting points.
2. Secure the Intercooler
Using the bolts you removed earlier, secure the Greddy intercooler in place. Make sure to tighten them evenly to avoid any misalignment.
3. Reconnect the Piping
Attach the piping to the new intercooler using the provided silicone couplers and hose clamps. Ensure that all connections are tight to prevent any boost leaks.
Final Steps
With the intercooler installed, you can now complete the remaining steps to finish your installation.
1. Refill the Cooling System
Close the radiator drain plug and refill the cooling system with the appropriate coolant. Follow the manufacturer’s specifications for the correct mixture.
2. Reattach the Front Bumper
Carefully reattach the front bumper, ensuring all clips and screws are secured properly. Double-check that there are no loose wires or components.
3. Reconnect the Battery
Finally, reconnect the negative terminal of the battery. Make sure it is secured tightly to avoid any electrical issues.
Testing the Installation
Once everything is reassembled, start the engine and let it idle for a few minutes. Check for any leaks around the intercooler and piping. Take the vehicle for a short test drive to ensure everything is functioning correctly.
Conclusion
Installing a Greddy intercooler on your Nissan Skyline R34 can significantly improve cooling efficiency and power output. By following these steps carefully, you can ensure a successful installation and enjoy the benefits of enhanced performance.