How to Install a Hre 19-inch Wheel Upgrade on Your R8 V10 Performance

by

Upgrading the wheels on your Audi R8 V10 Performance can significantly enhance both the aesthetics and performance of the vehicle. In this guide, we will walk you through the steps to install a HRE 19-inch wheel upgrade, ensuring that you achieve the best results while maintaining the integrity of your car.

Tools and Materials Needed

  • HRE 19-inch wheels
  • Jack and jack stands
  • Torque wrench
  • Socket set
  • Wheel lock key
  • Rags for cleaning
  • Brake cleaner

Preparation Steps

Before starting the installation, ensure that you have all the necessary tools and materials at hand. Follow these preparation steps:

  • Park your R8 on a flat surface.
  • Engage the parking brake.
  • Remove any hubcaps or wheel covers if applicable.
  • Loosen the lug nuts on each wheel slightly while the car is still on the ground.

Jack Up the Vehicle

To safely remove the wheels, you need to lift the vehicle. Follow these steps:

  • Use the jack to lift the front or rear of the vehicle, depending on which wheels you are changing first.
  • Place jack stands under the vehicle for added safety.
  • Make sure the vehicle is stable before proceeding.

Removing the Old Wheels

With the vehicle securely lifted, you can now remove the old wheels:

  • Use the wheel lock key to remove any locking lug nuts.
  • Completely unscrew the remaining lug nuts using your socket set.
  • Carefully remove the wheel and set it aside.

Preparing the New HRE Wheels

Before installing the new wheels, it’s important to prepare them properly:

  • Clean the hub surface with a rag and brake cleaner.
  • Inspect the new wheels for any defects.
  • Ensure that the lug holes are clean and free of debris.

Installing the HRE Wheels

Now it’s time to install your new HRE 19-inch wheels:

  • Align the wheel with the hub and gently push it onto the hub.
  • Hand-tighten the lug nuts to secure the wheel in place.
  • Repeat the process for each wheel being replaced.

Torque Specifications

After installing all the wheels, it is crucial to torque the lug nuts to the manufacturer’s specifications:

  • Refer to the owner’s manual for the correct torque settings.
  • Use a torque wrench to tighten each lug nut in a crisscross pattern.
  • Ensure that all lug nuts are properly secured.

Lowering the Vehicle

Once all wheels are installed and torqued, you can lower the vehicle:

  • Remove the jack stands carefully.
  • Lower the vehicle slowly using the jack.
  • Once on the ground, give the wheels a final inspection.

Final Checks

After installation, it’s important to perform a few final checks:

  • Check that all lug nuts are tightened to the specified torque.
  • Inspect the wheels for any signs of misalignment.
  • Take the car for a short drive and listen for any unusual noises.

Conclusion

Upgrading to HRE 19-inch wheels on your R8 V10 Performance can greatly enhance your driving experience. By following these steps carefully, you can ensure a successful installation. Enjoy your new wheels and the improved performance they bring!