Table of Contents
Installing a Level 3 Performance Transmission Kit from RPM Transmissions can significantly enhance your vehicle’s performance. This guide will take you through the process step-by-step, ensuring that you have all the necessary information to complete the installation successfully.
Tools and Materials Needed
- Level 3 Performance Transmission Kit from RPM Transmissions
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Transmission jack
- Oil catch pan
- Rags or shop towels
- Safety glasses and gloves
Preparation Steps
Before you begin the installation, it’s essential to prepare your workspace and vehicle. Follow these steps:
- Ensure your vehicle is parked on a flat surface.
- Disconnect the battery to prevent any electrical issues.
- Lift the vehicle using a jack and secure it with jack stands.
- Drain the transmission fluid into an oil catch pan.
Removing the Old Transmission
To install the new Level 3 Performance Transmission Kit, the old transmission must be removed. Follow these steps:
- Remove the drive shaft by unbolting it from the rear differential and sliding it out.
- Disconnect any electrical connectors attached to the transmission.
- Unbolt the transmission from the engine using the appropriate socket size.
- Support the transmission with a transmission jack and carefully lower it from the vehicle.
Installing the Level 3 Performance Transmission Kit
Once the old transmission is out, it’s time to install the new Level 3 Performance Transmission Kit. Follow these steps:
- Position the new transmission onto the transmission jack.
- Carefully lift the transmission into place, aligning it with the engine.
- Secure the transmission by bolting it back to the engine.
- Reconnect all electrical connectors that were previously disconnected.
- Reinstall the drive shaft by sliding it back into place and securing it with bolts.
Final Steps and Fluid Replacement
After the installation is complete, it’s crucial to perform the final steps to ensure everything is functioning correctly:
- Reconnect the battery and check all electrical connections for proper fit.
- Fill the transmission with the recommended fluid type as specified in the kit instructions.
- Start the vehicle and let it idle for a few minutes, checking for leaks.
- Take the vehicle for a short test drive to ensure the transmission shifts smoothly.
Troubleshooting Common Issues
If you encounter issues after installation, consider the following troubleshooting tips:
- Check for any fluid leaks around the transmission and drive shaft.
- Ensure all electrical connections are secure and functioning.
- Verify that the transmission fluid is at the correct level.
- If shifting issues occur, double-check the installation of the transmission and linkage.
Conclusion
Installing a Level 3 Performance Transmission Kit from RPM Transmissions can be a rewarding project that enhances your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved driving dynamics.