Table of Contents
Installing a Magnuson TVS1900 Supercharger on your Tundra can significantly enhance its performance. This guide will provide you with a comprehensive, step-by-step approach to ensure a successful installation.
Tools and Materials Needed
- Magnuson TVS1900 Supercharger Kit
- Socket set
- Torque wrench
- Screwdrivers (flathead and Phillips)
- Wrenches
- Vacuum line
- Coolant
- Engine oil
- Shop towels
- Safety glasses
- Gloves
Preparation Steps
Before starting the installation, ensure you have all the necessary tools and materials. Follow these preparation steps:
- Park the Tundra on a level surface.
- Disconnect the negative battery terminal to prevent electrical issues.
- Allow the engine to cool completely.
- Remove any accessories that may obstruct access to the engine.
Removing the Stock Components
The first major step involves removing the stock components that will be replaced by the supercharger. Follow these instructions:
- Remove the air intake assembly by loosening the clamps and disconnecting the sensors.
- Unbolt the factory throttle body and set it aside.
- Drain the coolant from the radiator to prevent spills during installation.
- Remove the factory intake manifold by unbolting it and disconnecting any attached hoses.
Installing the Magnuson TVS1900 Supercharger
With the stock components removed, you can now proceed with the installation of the Magnuson TVS1900 Supercharger. Follow these steps:
- Place the supercharger onto the engine block, aligning it with the mounting points.
- Secure the supercharger using the provided bolts and torque them to the manufacturer’s specifications.
- Reconnect the throttle body to the supercharger, ensuring a tight seal.
- Install the new intake manifold that comes with the supercharger kit.
Connecting the Accessories
After the supercharger is in place, you need to connect various accessories:
- Reconnect all vacuum lines according to the provided diagram.
- Attach the intake duct and ensure all clamps are tightened.
- Fill the coolant reservoir with the appropriate coolant mixture.
- Reconnect the negative battery terminal.
Final Checks and Testing
Before starting your Tundra, perform the following final checks:
- Double-check all connections and ensure there are no loose wires.
- Inspect for any coolant leaks around the newly installed components.
- Verify that the supercharger belt is properly aligned and tensioned.
- Start the engine and listen for any unusual noises.
Conclusion
Installing a Magnuson TVS1900 Supercharger on your Tundra can provide a significant boost in performance. By following these steps carefully, you can ensure a successful installation and enjoy the enhanced power of your vehicle.