Table of Contents
Installing a Mishimoto oil cooler on your Veloster N can significantly enhance engine performance and longevity. This guide will provide you with a detailed step-by-step process to successfully install the cooler, along with a cost breakdown to help you budget for the project.
Tools and Materials Needed
- Mishimoto oil cooler kit
- Socket set
- Wrenches
- Torque wrench
- Drill with appropriate bits
- Oil catch pan
- Rags or shop towels
- Safety glasses
- Jack and jack stands
Preparation
Before starting the installation, ensure that your vehicle is parked on a flat surface. Engage the parking brake and disconnect the battery to prevent any electrical issues during the installation process.
Step 1: Lift the Vehicle
Using a jack, lift the front of the Veloster N and secure it with jack stands. This will provide you with better access to the oil cooler area.
Step 2: Drain the Engine Oil
Place an oil catch pan under the oil pan and remove the oil drain plug. Allow the oil to drain completely before replacing the drain plug and tightening it to the manufacturer’s specifications.
Installing the Mishimoto Oil Cooler
Step 3: Remove the Front Bumper
To access the mounting area for the oil cooler, you will need to remove the front bumper. Start by unscrewing the screws and clips that hold the bumper in place, then gently pull it away from the vehicle.
Step 4: Install the Oil Cooler Bracket
Position the Mishimoto oil cooler bracket in the designated area. Use a drill to create any necessary holes for mounting. Secure the bracket using the provided hardware.
Step 5: Mount the Oil Cooler
Attach the oil cooler to the bracket using the bolts provided in the kit. Ensure that the cooler is level and securely fastened.
Step 6: Connect the Oil Lines
Connect the oil lines from the engine to the oil cooler. Make sure to follow the instructions provided in the Mishimoto kit for correct routing and connections. Tighten all fittings securely to prevent leaks.
Step 7: Reinstall the Front Bumper
Once the oil cooler is installed and connected, carefully reinstall the front bumper. Ensure that all screws and clips are reattached properly.
Final Steps
Step 8: Refill the Engine Oil
Remove the oil filler cap and pour in the recommended amount of new engine oil. Replace the cap once done.
Step 9: Check for Leaks
Reconnect the battery and start the engine. Allow it to run for a few minutes while checking for any oil leaks around the cooler and connections.
Step 10: Lower the Vehicle
Once you confirm there are no leaks, carefully lower the vehicle back to the ground.
Cost Breakdown
Here’s a simple breakdown of the costs associated with installing a Mishimoto oil cooler on your Veloster N:
- Mishimoto oil cooler kit: $400
- Tools (if not already owned): $150
- Oil (5 quarts): $30
- Miscellaneous supplies (rags, catch pan): $20
Total estimated cost: $600
Conclusion
By following this step-by-step guide, you can successfully install a Mishimoto oil cooler on your Veloster N. Not only will this upgrade improve your vehicle’s performance, but it will also help maintain optimal engine temperatures during spirited driving.