Table of Contents
Upgrading your Dodge Durango SRT with a PowerStop brake kit can significantly enhance its performance and safety. This article provides a step-by-step guide on how to install the brake kit effectively.
Why Upgrade to a PowerStop Brake Kit?
PowerStop brake kits are designed to improve stopping power, reduce brake fade, and enhance overall vehicle safety. Here are some reasons to consider this upgrade:
- Improved Stopping Power: Enhanced performance for high-speed driving.
- Less Brake Fade: Better performance under heavy braking conditions.
- Noise Reduction: Quieter operation compared to stock brakes.
- Complete Kit: Everything needed for a full brake upgrade.
Tools and Materials Needed
Before starting the installation, gather the following tools and materials:
- PowerStop brake kit
- Jack and jack stands
- Socket set
- Torque wrench
- Brake cleaner
- Brake grease
- Safety glasses
- Gloves
Step-by-Step Installation Guide
Step 1: Prepare Your Vehicle
Start by parking your Dodge Durango SRT on a level surface. Engage the parking brake and place wheel chocks behind the rear wheels. This ensures the vehicle remains stable during the installation process.
Step 2: Remove the Wheels
Using a jack, lift the front of the vehicle and secure it with jack stands. Remove the lug nuts with a socket wrench and take off the front wheels to access the brake components.
Step 3: Remove the Old Brake Components
Locate the brake caliper and remove the bolts securing it in place. Carefully slide the caliper off the rotor. Support the caliper with a bungee cord or similar device to avoid straining the brake line.
Next, remove the old brake pads from the caliper bracket. If necessary, use a C-clamp to compress the caliper piston to make room for the new pads.
Step 4: Install the New Brake Pads and Rotors
Remove the old rotor by unscrewing any retaining screws. Place the new PowerStop rotor onto the hub, ensuring it is seated correctly. Apply brake cleaner to the rotor to remove any protective oil.
Install the new brake pads into the caliper bracket. Ensure they are aligned properly and apply a thin layer of brake grease to the backing of the pads to reduce noise.
Step 5: Reattach the Caliper
Carefully slide the caliper back over the new brake pads and rotor. Reinstall the caliper bolts and tighten them to the manufacturer’s specifications using a torque wrench.
Step 6: Reinstall the Wheels
Place the wheels back onto the wheel hubs and hand-tighten the lug nuts. Lower the vehicle back to the ground and then use the torque wrench to tighten the lug nuts to the specified torque.
Step 7: Repeat for the Rear Brakes
Follow the same steps to install the PowerStop brake kit on the rear brakes. Ensure all components are installed correctly and securely.
Final Steps
After installing the brake kit, pump the brake pedal a few times to seat the pads against the rotors properly. Check the brake fluid level and top it off if necessary.
Finally, take your Dodge Durango SRT for a test drive in a safe area to ensure the brakes are functioning correctly. Pay attention to any unusual noises or behaviors.
Conclusion
Installing a PowerStop brake kit on your Dodge Durango SRT is a straightforward process that can greatly enhance your vehicle’s performance and safety. With the right tools and careful attention to detail, you can enjoy improved stopping power and a more confident driving experience.