How to Install a Revodrive X8 Driveshaft: Step-by-step for 30 Hp Gains

by

The RevoDrive X8 Driveshaft is a high-performance component designed to enhance your vehicle’s efficiency and power output. Installing this driveshaft can lead to significant horsepower gains, often up to 30 HP. This guide will walk you through the step-by-step process of installing the RevoDrive X8 Driveshaft, ensuring you achieve optimal performance.

Tools and Materials Needed

  • RevoDrive X8 Driveshaft
  • Socket set
  • Torque wrench
  • Jack and jack stands
  • Safety glasses
  • Gloves
  • Lubricant

Preparation Steps

Before starting the installation, ensure that you have all the necessary tools and materials. Follow these preparation steps to set up your workspace:

  • Park your vehicle on a flat, level surface.
  • Engage the parking brake.
  • Disconnect the battery to prevent any electrical issues.
  • Put on safety glasses and gloves for protection.

Step 1: Lifting the Vehicle

To access the driveshaft, you will need to lift the vehicle. Follow these instructions:

  • Use a jack to lift the rear of the vehicle.
  • Secure the vehicle with jack stands to ensure stability.

Step 2: Removing the Old Driveshaft

Once the vehicle is safely lifted, you can proceed to remove the old driveshaft. Here’s how:

  • Locate the bolts securing the old driveshaft to the differential and transmission.
  • Using the socket set, carefully remove these bolts.
  • Once the bolts are removed, gently pull the old driveshaft out of the yoke.
  • Inspect the old driveshaft for any signs of wear or damage.

Step 3: Preparing the New Driveshaft

Before installing the new RevoDrive X8 Driveshaft, it’s essential to prepare it properly:

  • Apply a small amount of lubricant to the yoke of the new driveshaft.
  • Ensure that the driveshaft is aligned correctly for installation.

Step 4: Installing the RevoDrive X8 Driveshaft

Now it’s time to install the new driveshaft. Follow these steps carefully:

  • Slide the new driveshaft into the yoke on the differential.
  • Align the driveshaft with the transmission yoke.
  • Once aligned, push the driveshaft fully into the yoke.
  • Reinstall the bolts that secure the driveshaft to the differential and transmission.

Step 5: Torque Specifications

It’s crucial to follow the manufacturer’s torque specifications for the driveshaft bolts:

  • Refer to the RevoDrive installation manual for specific torque settings.
  • Using a torque wrench, tighten the bolts to the specified torque.

Step 6: Final Checks

Before lowering the vehicle, perform these final checks:

  • Ensure all bolts are securely tightened.
  • Check for any signs of interference or misalignment.
  • Reconnect the battery.

Step 7: Lowering the Vehicle

Once everything is checked, you can safely lower the vehicle:

  • Remove the jack stands.
  • Carefully lower the vehicle using the jack.

Step 8: Test Drive

After the installation, it’s essential to take the vehicle for a test drive to ensure everything is functioning correctly:

  • Start the vehicle and listen for any unusual noises.
  • Take the vehicle for a short drive, paying attention to the performance.
  • Check for any vibrations or issues during the drive.

Conclusion

Installing the RevoDrive X8 Driveshaft can significantly enhance your vehicle’s performance, providing up to 30 HP gains. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved efficiency and power.