Table of Contents
Installing a Skunk2 Stage 2 camshaft on your B-series engine can yield significant horsepower gains, often exceeding 20 HP. This guide will walk you through the necessary steps to ensure a successful installation.
Tools and Materials Needed
- Skunk2 Stage 2 Camshaft
- Socket set
- Torque wrench
- Engine oil
- Camshaft installation tool
- Timing belt kit
- Gasket set
- Rags and cleaning supplies
Preparation
Before beginning the installation, ensure your work area is clean and organized. Gather all tools and materials. It’s also a good idea to review the vehicle’s service manual for specific torque specifications and procedures.
Step-by-Step Installation
1. Remove the Engine Cover
Start by removing the engine cover to access the camshaft area. This typically involves unscrewing a few bolts. Set the cover aside in a safe location.
2. Disconnect the Battery
For safety, disconnect the negative terminal of the battery. This will prevent any electrical issues during the installation process.
3. Remove the Timing Belt
Carefully remove the timing belt by loosening the tensioner. Make sure to note the belt’s routing for reinstallation. It’s advisable to replace the timing belt if it shows signs of wear.
4. Remove the Old Camshaft
Unbolt the old camshaft using the appropriate socket. Be cautious when removing it, as you want to avoid damaging any surrounding components. Clean the camshaft area thoroughly before installation.
5. Install the Skunk2 Stage 2 Camshaft
Carefully place the Skunk2 Stage 2 camshaft into position. Ensure it is aligned correctly with the timing marks. Use the camshaft installation tool if necessary to assist with the alignment.
6. Reinstall the Timing Belt
Once the camshaft is in place, reinstall the timing belt. Make sure the belt is taut and properly aligned with the timing marks. Tighten the tensioner to secure the belt.
7. Reconnect the Battery and Engine Cover
Reconnect the negative terminal of the battery. Then, replace the engine cover, securing it with the bolts you removed earlier.
Post-Installation Checks
After installation, it’s essential to perform a few checks to ensure everything is functioning correctly.
- Check for any leaks around the camshaft area.
- Verify that all bolts are tightened to the specified torque.
- Start the engine and listen for any unusual noises.
- Monitor engine performance and check for error codes.
Conclusion
Installing a Skunk2 Stage 2 camshaft on your B-series engine can significantly enhance performance. By following these steps and performing thorough checks, you can ensure a successful installation and enjoy the benefits of increased horsepower.