Table of Contents
Installing a Toda Racing Exhaust System on your Acura Integra Type R can enhance performance and provide a more aggressive sound. This guide will walk you through the steps to ensure a successful installation.
Tools and Materials Needed
- Socket set
- Wrench set
- Torque wrench
- Jack and jack stands
- Safety goggles
- Gloves
- Toda Racing Exhaust System
- New exhaust gaskets
Before starting the installation, gather all necessary tools and materials. This will streamline the process and ensure you have everything at hand.
Preparation
Make sure your vehicle is parked on a level surface. Engage the parking brake and disconnect the battery to prevent any electrical issues during installation.
Lift the Vehicle
Using a jack, lift the rear of the Acura Integra Type R and secure it with jack stands. Ensure the vehicle is stable before proceeding.
Removing the Old Exhaust System
Begin by locating the existing exhaust system components. You will need to remove the rear section first.
Loosen Exhaust Clamps
Use your socket set to loosen the clamps securing the exhaust pipes. Be cautious of any rust or corrosion that may have built up over time.
Detach the Exhaust Hangars
Carefully detach the exhaust hangars using a wrench. You may need to apply some lubricant to make this easier. Keep the hangars for reinstallation if they are in good condition.
Remove the Old Exhaust
Once the clamps and hangars are removed, gently pull the old exhaust system out from the vehicle. Be mindful of any sharp edges or hot components.
Installing the Toda Racing Exhaust System
With the old exhaust removed, it’s time to install the new Toda Racing Exhaust System. Follow these steps carefully to ensure a proper fit.
Position the New Exhaust
Align the new exhaust system with the mounting points on your Acura Integra Type R. Ensure that the flanges are correctly positioned to match the exhaust manifold.
Secure the Exhaust with Clamps
Once positioned, secure the exhaust using the provided clamps. Tighten them enough to hold the exhaust in place without over-tightening, which could cause damage.
Reattach Exhaust Hangars
Reattach the exhaust hangars to the mounting points. Ensure they are securely fastened to prevent any rattling or movement during driving.
Final Adjustments and Checks
With the exhaust system installed, it’s important to make final checks to ensure everything is secure and functioning correctly.
Check for Leaks
Start the engine and let it idle. Check for any exhaust leaks around the flanges and joints. If you notice any hissing or escaping exhaust, re-tighten the clamps and fittings.
Lower the Vehicle
Once you’ve confirmed there are no leaks, carefully lower the vehicle back to the ground. Remove the jack stands and jack.
Conclusion
Installing a Toda Racing Exhaust System on your Acura Integra Type R can significantly improve performance and sound. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of your new exhaust system.