How to Install a Walker High Flow Catalytic Converter in 3 Easy Steps

by

Installing a Walker High Flow Catalytic Converter can enhance your vehicle’s performance while ensuring compliance with emissions regulations. Follow these three easy steps to successfully install your new catalytic converter.

Step 1: Gather Your Tools and Materials

Before you begin the installation process, make sure you have all the necessary tools and materials on hand. This will help you complete the installation smoothly and efficiently.

  • Walker High Flow Catalytic Converter
  • Socket set
  • Wrench set
  • Jack and jack stands
  • Safety goggles
  • Gloves
  • Exhaust pipe cutter or saw
  • Pipe wrench
  • New gaskets

Step 2: Prepare Your Vehicle

Proper preparation is essential for a successful installation. Follow these steps to prepare your vehicle for the catalytic converter installation.

  • Park your vehicle on a flat surface and engage the parking brake.
  • Lift the vehicle using a jack and secure it with jack stands.
  • Wear safety goggles and gloves to protect yourself.
  • Locate the existing catalytic converter under the vehicle.

Step 3: Remove the Old Catalytic Converter

Now that your vehicle is prepared, it’s time to remove the old catalytic converter. Follow these steps carefully.

  • Use a socket or wrench to loosen and remove the bolts securing the old catalytic converter.
  • Carefully detach the old converter from the exhaust system.
  • If necessary, use an exhaust pipe cutter or saw to cut the pipe if it is too rusted or damaged.
  • Remove any old gaskets and clean the mating surfaces to ensure a good seal with the new converter.

Installing the Walker High Flow Catalytic Converter

With the old catalytic converter removed, you can now install the new Walker High Flow Catalytic Converter. Follow these instructions:

  • Position the new catalytic converter in place, aligning it with the exhaust pipes.
  • Install new gaskets to ensure a proper seal.
  • Secure the converter with bolts, tightening them evenly to avoid leaks.
  • Double-check all connections and ensure everything is secure.

Final Steps

After the installation is complete, follow these final steps to ensure everything is in order.

  • Lower the vehicle back to the ground using the jack.
  • Start the engine and listen for any unusual noises or leaks.
  • Check for leaks around the newly installed catalytic converter.
  • Dispose of the old catalytic converter according to local regulations.

By following these three easy steps, you can successfully install a Walker High Flow Catalytic Converter and enjoy improved vehicle performance. Always remember to prioritize safety and consult a professional if you have any doubts during the installation process.