Table of Contents
Installing a Whiteline suspension kit on your BRZ can significantly enhance its handling and performance. This guide will walk you through the process step-by-step, ensuring you have all the necessary information to complete the installation successfully.
What You Will Need
- Whiteline suspension kit
- Jack and jack stands
- Socket set
- Wrench set
- Torque wrench
- Pliers
- Grease
- Safety glasses
Before you start, make sure you have all the tools and equipment ready. Having everything at hand will make the installation process smoother.
Preparing Your Vehicle
Before installing the suspension kit, ensure your vehicle is parked on a flat surface and the engine is off. Follow these steps:
- Loosen the lug nuts on the wheels but do not remove them yet.
- Using a jack, lift the vehicle and secure it with jack stands.
- Remove the wheels to access the suspension components.
Always remember to wear safety glasses during this process to protect your eyes from debris.
Removing the Old Suspension
Now that your vehicle is prepared, it’s time to remove the old suspension components. Follow these steps:
- Locate the strut assembly and remove the bolts securing it to the hub.
- Disconnect any brake lines or sensors attached to the strut.
- Remove the upper strut mounting bolts from the engine bay.
- Carefully pull the strut assembly out of the vehicle.
Repeat these steps for the rear suspension components if applicable.
Installing the Whiteline Suspension Kit
With the old suspension removed, you can now install the Whiteline suspension kit. Follow these steps:
- Take the new strut assembly from the Whiteline kit and position it in place.
- Secure the strut to the hub using the original bolts.
- Reconnect any brake lines or sensors that were disconnected.
- Install the upper strut mounting bolts and tighten them to the manufacturer’s specifications.
Ensure that all components are securely fastened before moving on to the next step.
Adjusting the Suspension Settings
Once the suspension kit is installed, you will need to adjust the settings according to your driving preferences. Follow these steps:
- Refer to the Whiteline installation manual for specific adjustment instructions.
- Adjust the ride height and damping settings as desired.
- Make sure to check that all adjustments are within the recommended ranges.
Proper adjustments will optimize your vehicle’s performance and handling.
Reassembling Your Vehicle
After adjusting the suspension, it’s time to reassemble your vehicle. Follow these steps:
- Reinstall the wheels and hand-tighten the lug nuts.
- Lower the vehicle back to the ground using the jack.
- Once on the ground, use a torque wrench to tighten the lug nuts to the specified torque settings.
Double-check that everything is in place before taking your vehicle for a test drive.
Testing Your Installation
With the installation complete, it’s crucial to test your vehicle to ensure everything is functioning correctly. Follow these steps:
- Take your vehicle for a short drive to feel the new suspension performance.
- Pay attention to any unusual noises or handling issues.
- If everything feels good, perform a full alignment to ensure proper handling.
Regularly inspect the suspension components for any signs of wear or damage after installation.
Conclusion
Installing a Whiteline suspension kit on your BRZ can be a rewarding project that enhances your driving experience. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved handling and performance.