How to Install an Aem Cold Air Intake on Your Toyota Gr Corolla for Better Performance

by

The Toyota GR Corolla is a performance-oriented hatchback that has captured the hearts of car enthusiasts. One of the best ways to enhance its performance is by installing an AEM cold air intake. This guide will walk you through the steps required to install this aftermarket part, ensuring that you can enjoy improved horsepower and throttle response.

What You Will Need

  • AEM Cold Air Intake Kit
  • Socket set
  • Ratchet
  • Torque wrench
  • Flathead screwdriver
  • Phillips screwdriver
  • Shop towels
  • Safety glasses

Safety Precautions

Before starting the installation process, it’s essential to take safety precautions:

  • Always wear safety glasses to protect your eyes.
  • Ensure the vehicle is parked on a flat surface and the engine is cool.
  • Disconnect the battery to prevent any electrical issues.

Step-by-Step Installation Process

Step 1: Remove the Engine Cover

Begin by removing the engine cover. Use a socket to unscrew the bolts holding the cover in place. Once removed, set it aside in a safe location.

Step 2: Disconnect the Mass Air Flow Sensor

Locate the mass air flow (MAF) sensor on the factory intake. Carefully disconnect the electrical connector by pressing the release tab and pulling it away.

Step 3: Remove the Factory Intake

Next, loosen the clamps on the factory intake tube using a flathead screwdriver. Remove any bolts securing the intake to the engine bay. Carefully pull the intake out and set it aside.

Step 4: Install the AEM Cold Air Intake

Now it’s time to install the AEM cold air intake. Begin by placing the new intake tube in position. Make sure it aligns properly with the throttle body.

Step 5: Secure the Intake

Use the provided clamps to secure the intake tube to the throttle body. Tighten the clamps using a socket or ratchet, but be careful not to overtighten.

Step 6: Reconnect the Mass Air Flow Sensor

Reconnect the MAF sensor by pushing the electrical connector back into place until it clicks. Ensure it is secure and properly seated.

Step 7: Install the Air Filter

Attach the AEM air filter to the end of the intake tube. Ensure it is fitted securely and that there are no gaps.

Step 8: Reinstall the Engine Cover

Place the engine cover back on and secure it with the previously removed bolts. Double-check that everything is tightened properly.

Step 9: Reconnect the Battery

Reconnect the battery terminals, ensuring they are tight and secure. This will restore power to the vehicle.

Final Checks

Before starting your car, take a moment to inspect your work:

  • Check for any loose connections or clamps.
  • Ensure the MAF sensor is properly connected.
  • Make sure the air filter is securely attached.

Testing the New Intake

Once everything is checked, start your vehicle and listen for any unusual sounds. Take the car for a short test drive to feel the difference in performance. You should notice improved throttle response and a more aggressive sound.

Conclusion

Installing an AEM cold air intake on your Toyota GR Corolla is a straightforward process that can significantly enhance your vehicle’s performance. By following the steps outlined in this guide, you can enjoy the benefits of increased horsepower and better engine efficiency. Happy driving!