How to Install an Ams Launch Technique Module on a Nissan 370z: Step-by-step

by

The Nissan 370Z is a popular sports car known for its performance and handling. One way to enhance its capabilities is by installing an AMS Launch Technique Module. This guide will walk you through the step-by-step process of installing this module.

What You Will Need

  • AMS Launch Technique Module
  • Socket wrench set
  • Screwdrivers (flathead and Phillips)
  • Wire cutters and strippers
  • Electrical tape
  • Safety glasses
  • Gloves

Preparation Steps

Before starting the installation, ensure that you have all the necessary tools and equipment ready. It’s also important to work in a well-ventilated area and ensure the car is parked on a flat surface.

Step 1: Disconnect the Battery

To prevent any electrical issues, begin by disconnecting the negative terminal of the battery. Use a socket wrench to loosen the bolt and remove the cable.

Step 2: Locate the ECU

The ECU (Engine Control Unit) is typically located under the dashboard on the driver’s side of the vehicle. Remove any panels or coverings that may obstruct access to the ECU.

Step 3: Remove the ECU Connector

Carefully disconnect the ECU connector by pressing the release tab and pulling the connector away from the ECU. Be gentle to avoid damaging any pins.

Step 4: Prepare the AMS Module

Take the AMS Launch Technique Module out of its packaging. Review the wiring diagram included with the module to familiarize yourself with the connections.

Step 5: Connect the Module

Using the wiring diagram, connect the AMS module to the ECU connector. Make sure each wire is securely connected and that there are no loose ends. Use wire strippers if necessary to expose the wire ends.

Step 6: Secure the Connections

Once all connections are made, use electrical tape to secure each connection. This will help prevent any shorts or disconnections while driving.

Step 7: Reconnect the ECU

Reconnect the ECU connector by aligning it properly and pushing it back into place until you hear a click. Ensure it is firmly attached.

Step 8: Reinstall Panels

Replace any panels or coverings that were removed to access the ECU. Make sure everything is secure and in place.

Step 9: Reconnect the Battery

Reconnect the negative terminal of the battery. Tighten the bolt securely to ensure a good connection.

Step 10: Test the Installation

Start the vehicle to test the installation. Ensure that the AMS Launch Technique Module is functioning correctly. Check for any warning lights on the dashboard and listen for any unusual sounds.

Conclusion

Installing an AMS Launch Technique Module on your Nissan 370Z can significantly enhance your driving experience. By following these steps carefully, you can ensure a successful installation. Always remember to consult the manufacturer’s instructions for specific details related to your module.