Table of Contents
The Mitsubishi Evolution series has long been celebrated for its performance and tuning potential. One of the most popular upgrades among enthusiasts is the AMS Performance Stage 2 Kit. This kit enhances the power and efficiency of your Evo, making it a thrilling ride. In this guide, we will walk you through the steps to install the AMS Performance Stage 2 Kit on your Mitsubishi Evo.
Tools and Materials Needed
- AMS Performance Stage 2 Kit
- Socket set
- Wrenches
- Torque wrench
- Flathead screwdriver
- Phillips screwdriver
- Ratchet
- Jack and jack stands
- Safety goggles
- Gloves
Preparation
Before you begin the installation, it’s essential to prepare your workspace and vehicle. Make sure you have all the tools and materials ready. Additionally, ensure your Mitsubishi Evo is parked on a flat surface and the engine is cool.
Step 1: Disconnect the Battery
Safety is paramount. Start by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation process.
Step 2: Lift the Vehicle
Use a jack to lift the front of the vehicle and secure it with jack stands. This will provide you with enough clearance to work underneath the car.
Removing Stock Components
To install the AMS Performance Stage 2 Kit, you will need to remove several stock components from your Mitsubishi Evo.
Step 3: Remove the Stock Intake System
Start by removing the stock intake system. This typically involves disconnecting the air filter, intake piping, and any sensors attached to the intake. Make sure to keep all screws and clamps for reinstallation.
Step 4: Remove the Stock Turbocharger
Next, you will need to remove the stock turbocharger. Disconnect the wastegate actuator, oil feed and return lines, and any other connections. Carefully unbolt the turbo from the exhaust manifold and remove it from the vehicle.
Installing the AMS Performance Stage 2 Kit
With the stock components removed, it’s time to install the AMS Performance Stage 2 Kit.
Step 5: Install the New Turbocharger
Begin by installing the new turbocharger from the AMS Performance Stage 2 Kit. Secure it to the exhaust manifold using the provided hardware. Reconnect the oil feed and return lines, as well as the wastegate actuator.
Step 6: Install the New Intake System
Next, install the new intake system. This includes the new air filter and intake piping. Ensure all connections are tight and secure, and reattach any sensors that were removed.
Final Steps
After installing the AMS Performance Stage 2 Kit, there are a few final steps to complete before you can hit the road.
Step 7: Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure that it is secured and free of corrosion.
Step 8: Check for Leaks
Before starting the engine, check all connections for leaks, especially around the turbo and intake system. Tighten any loose connections as needed.
Step 9: Start the Engine
Start the engine and let it idle for a few minutes. Monitor the engine for any unusual sounds or issues. If everything looks good, take the car for a test drive to experience the enhanced performance.
Conclusion
Installing the AMS Performance Stage 2 Kit on your Mitsubishi Evo can significantly enhance its performance and driving experience. By following this step-by-step guide, you can complete the installation with confidence. Always remember to take your time and double-check your work for the best results.