Table of Contents
The Grand Cherokee SRT is a powerful SUV that combines performance and luxury. To enhance its aerodynamics and downforce, installing an APR front splitter and spoiler is a popular modification. This guide will walk you through the steps required to install these components effectively.
Tools and Materials Needed
- APR front splitter kit
- APR rear spoiler kit
- Socket wrench set
- Drill with drill bits
- Measuring tape
- Level
- Safety glasses
- Torque wrench
- Adhesive promoter (if needed)
Preparation
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is turned off. Gather all tools and materials required for the installation. Wearing safety glasses is recommended to protect your eyes during the process.
Removing the Front Bumper
To install the front splitter, the front bumper must be removed. Follow these steps:
- Locate and remove the screws or bolts securing the bumper to the vehicle.
- Disconnect any fog lights or sensors attached to the bumper.
- Carefully pull the bumper away from the vehicle, ensuring no clips are broken.
Installing the Front Splitter
With the bumper removed, you can now install the APR front splitter:
- Position the front splitter against the bottom of the bumper.
- Use a measuring tape to ensure it is centered and level.
- Mark the drilling points through the splitter’s mounting holes.
- Drill the marked holes carefully.
- Attach the splitter using the provided screws and a socket wrench, ensuring a tight fit.
Reinstalling the Front Bumper
After the front splitter is securely attached, reinstall the front bumper:
- Align the bumper with the vehicle and push it into place.
- Reconnect any fog lights or sensors that were disconnected.
- Screw or bolt the bumper back to the vehicle, ensuring all fasteners are tight.
Installing the Rear Spoiler
Now that the front splitter is installed, it’s time to add the APR rear spoiler. Follow these steps:
- Clean the area on the rear hatch where the spoiler will be mounted.
- Use a measuring tape to find the center of the hatch.
- Mark the drilling points based on the spoiler’s mounting holes.
- Drill the holes carefully, ensuring not to damage any underlying components.
- Apply adhesive promoter if required, then position the spoiler onto the hatch.
- Secure the spoiler with screws using a socket wrench.
Final Checks and Testing
Once both the front splitter and rear spoiler are installed, perform a final check:
- Ensure all screws and bolts are tightened properly.
- Check the alignment of both components.
- Take the vehicle for a test drive to feel the enhanced downforce and stability.
Conclusion
Installing an APR front splitter and rear spoiler on your Grand Cherokee SRT can significantly improve its aerodynamics and performance. By following these steps, you can ensure a successful installation that enhances your driving experience.