Table of Contents
Installing an AWE Tuning exhaust system on your GR86 can significantly enhance the performance and sound of your vehicle. This guide will walk you through the step-by-step process to ensure a smooth installation.
Tools and Materials Needed
- Socket set
- Wrench set
- Torque wrench
- Jack stands
- Rubber mallet
- Lubricant spray
- AWE Tuning exhaust system
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure your vehicle is parked on a level surface and the engine is cool. Gather all the necessary tools and materials to avoid interruptions during the process.
Step 1: Raise the Vehicle
Use a jack to lift the rear of the GR86 and secure it with jack stands. This will provide you with enough space to work comfortably under the car.
Step 2: Remove the Stock Exhaust System
Locate the stock exhaust system and use a socket wrench to remove the bolts connecting the exhaust to the headers and the hangers. Be cautious as some parts may be rusted and require additional force.
Once the bolts are removed, gently tap the exhaust with a rubber mallet if necessary to loosen it from the hangers. Carefully lower the stock exhaust system and set it aside.
Step 3: Prepare the AWE Tuning Exhaust System
Unbox the AWE Tuning exhaust system and lay out all components to ensure nothing is missing. Refer to the installation manual included with the exhaust system for specific details regarding each part.
Step 4: Install the AWE Tuning Exhaust System
Begin by positioning the AWE Tuning exhaust system in place. Align it with the hangers and headers. Start by loosely attaching the bolts to secure the exhaust but do not fully tighten them yet.
Make sure everything is aligned correctly and adjust as necessary. Once satisfied with the fit, use a torque wrench to tighten all bolts to the manufacturer’s specifications.
Step 5: Recheck Connections
After the installation is complete, double-check all connections to ensure they are secure. Pay attention to the hangers and ensure they are properly mounted to avoid any rattling or misalignment during operation.
Step 6: Lower the Vehicle
Once everything is checked, carefully lower the vehicle from the jack stands using the jack. Make sure to remove the jack stands before lowering the car completely.
Step 7: Test the Exhaust System
Start the engine and let it idle for a few minutes. Listen for any unusual sounds that may indicate a leak or improper installation. If everything sounds normal, take the car for a short drive to test the performance and sound of the new exhaust system.
Conclusion
Installing an AWE Tuning exhaust system on your GR86 can be a rewarding project that enhances your driving experience. By following this step-by-step guide, you can ensure a successful installation and enjoy the improved performance and sound of your vehicle.