Table of Contents
Installing an AWE Tuning exhaust and ECU tune on your RS6 4.0TT can significantly enhance its performance and sound. This step-by-step guide will walk you through the process to ensure a successful installation.
Tools and Materials Needed
- AWE Tuning Exhaust System
- ECU Tune Software
- Socket Set
- Torque Wrench
- Jack and Jack Stands
- Safety Glasses
- Gloves
- Rags for Clean-Up
Preparation
Before starting the installation, make sure you have all the necessary tools and materials ready. Park your RS6 4.0TT on a flat surface and engage the parking brake.
Step 1: Raise the Vehicle
Using a jack, raise the vehicle and secure it with jack stands. Ensure the vehicle is stable before proceeding.
Step 2: Remove the Stock Exhaust
Locate the stock exhaust system and use a socket set to remove the bolts securing it to the exhaust hangers and downpipes. Carefully lower and remove the stock exhaust from the vehicle.
Installing the AWE Tuning Exhaust
Now that the stock exhaust is removed, it’s time to install the AWE Tuning exhaust system.
Step 3: Position the AWE Exhaust
Lift the AWE Tuning exhaust into position. Align it with the downpipes and exhaust hangers.
Step 4: Secure the Exhaust
Using the provided hardware, secure the exhaust system to the hangers and downpipes. Make sure everything is aligned properly before tightening.
Step 5: Tighten Bolts
Using a torque wrench, tighten all bolts to the manufacturer’s specifications. Double-check all connections to ensure there are no leaks.
ECU Tune Installation
With the exhaust installed, the next step is to upload the ECU tune.
Step 6: Connect the ECU Tuning Tool
Connect the ECU tuning tool to your vehicle’s OBD-II port. Ensure the ignition is in the “On” position without starting the engine.
Step 7: Upload the Tune
Follow the instructions provided with your ECU tuning software to upload the new tune. This process may take several minutes.
Step 8: Verify the Installation
Once the upload is complete, verify that the tuning tool indicates a successful installation. Disconnect the tool from the OBD-II port.
Final Steps
With both the exhaust and ECU tune installed, it’s important to perform a final check before taking your RS6 4.0TT for a test drive.
Step 9: Lower the Vehicle
Carefully lower the vehicle back to the ground and remove the jack stands.
Step 10: Start the Engine
Start the engine and listen for any unusual noises. Check for exhaust leaks around the connections.
Step 11: Test Drive
Take your RS6 4.0TT for a test drive to experience the improved performance and sound. Monitor the vehicle’s behavior and ensure everything is functioning correctly.
Conclusion
Installing an AWE Tuning exhaust and ECU tune on your RS6 4.0TT can greatly enhance its performance. By following this step-by-step guide, you can enjoy your vehicle’s full potential.