Table of Contents
Installing the Edelbrock Performer RPM camshaft on your Chevelle SS can significantly enhance its performance. This guide walks you through the step-by-step process to ensure a successful installation.
Tools and Materials Needed
- Edelbrock Performer RPM Camshaft
- Socket set
- Torque wrench
- Engine oil
- Camshaft installation tool
- Gasket set
- Timing chain set
- Valve spring compressor
Before starting the installation, gather all the necessary tools and materials. Having everything ready will streamline the process.
Preparation Steps
Ensure that your Chevelle SS is parked on a level surface and the engine is cold. Disconnect the battery to prevent any electrical issues during the installation.
Remove the Old Camshaft
To remove the old camshaft, follow these steps:
- Drain the engine oil and remove the oil pan.
- Remove the timing cover and timing chain.
- Take off the intake manifold and cylinder heads.
- Use a valve spring compressor to remove the valve springs and retainers.
- Carefully pull out the old camshaft.
Make sure to keep track of all components removed for reassembly.
Installing the Edelbrock Performer RPM Camshaft
With the old camshaft removed, it’s time to install the new Edelbrock Performer RPM camshaft. Follow these steps:
- Apply a thin coat of engine oil to the new camshaft.
- Carefully slide the new camshaft into place, ensuring it aligns with the cam bearings.
- Reinstall the valve springs using the valve spring compressor.
- Reattach the cylinder heads and torque them to the manufacturer’s specifications.
- Install the intake manifold and ensure all gaskets are seated properly.
Double-check all connections and ensure everything is tightened to the correct specifications.
Reassembly and Final Steps
Once the camshaft is installed, it’s time to reassemble the engine:
- Reinstall the timing chain and cover.
- Replace the oil pan and refill with new engine oil.
- Reconnect the battery.
- Start the engine and check for any leaks.
- Allow the engine to reach operating temperature and adjust the timing as necessary.
After ensuring everything is functioning correctly, take your Chevelle SS for a test drive to experience the power boost from your new camshaft.
Conclusion
Installing the Edelbrock Performer RPM camshaft on your Chevelle SS is a rewarding project that can enhance your vehicle’s performance. By following these steps carefully, you can ensure a successful installation and enjoy the benefits of improved power and efficiency.