Table of Contents
The Mitsubishi Lancer Evolution X is a performance vehicle that has captured the hearts of car enthusiasts around the world. One of the most sought-after modifications for this car is the BoostLogic Anti-Lag System, which enhances turbo responsiveness and overall performance. In this guide, we will walk you through the steps to install the BoostLogic Anti-Lag System in your Evo X.
What You Will Need
- BoostLogic Anti-Lag System Kit
- Basic hand tools (screwdrivers, wrenches, etc.)
- Socket set
- Wire crimping tool
- Soldering iron and solder
- Heat shrink tubing
- Electrical tape
- Safety glasses
Preparation Steps
Before you begin the installation process, it’s essential to prepare your workspace and gather all necessary tools and materials. Make sure your vehicle is parked on a flat surface and that you have ample lighting.
Step 1: Disconnect the Battery
Safety should always be your top priority. Start by disconnecting the negative terminal of the battery to prevent any electrical shorts during the installation.
Step 2: Remove the Engine Cover
Next, remove the engine cover to access the necessary components. Use the appropriate socket to unscrew the bolts and carefully lift the cover off.
Installing the BoostLogic Anti-Lag System
With the engine cover removed, you can now proceed with the installation of the BoostLogic Anti-Lag System.
Step 3: Install the Anti-Lag Module
Locate a suitable mounting location for the Anti-Lag module. It should be secure and easily accessible. Once you’ve found the spot, use the provided screws to mount the module.
Step 4: Wiring Connections
Follow the wiring diagram included in the BoostLogic kit to connect the Anti-Lag module to the vehicle’s electrical system. Ensure all connections are secure and insulated with heat shrink tubing and electrical tape.
Step 5: Connect to the ECU
Identify the ECU connector and carefully connect the Anti-Lag system wires as per the instructions. Be cautious to avoid damaging any pins during this process.
Step 6: Reassemble the Engine Cover
Once all wiring is complete, carefully reattach the engine cover. Ensure all bolts are tightened to prevent any rattling.
Testing the System
After installation, it’s crucial to test the BoostLogic Anti-Lag System to ensure everything is functioning correctly.
Step 7: Reconnect the Battery
Reconnect the negative terminal of the battery. This will power up the Anti-Lag system.
Step 8: Start the Engine
Start your Mitsubishi Lancer Evolution X and allow the engine to idle for a few minutes. Check for any warning lights on the dashboard.
Step 9: Test Anti-Lag Functionality
To test the Anti-Lag functionality, rev the engine while holding the brake pedal. You should hear the characteristic sounds of the Anti-Lag system engaging. If everything sounds normal, you’re good to go!
Conclusion
Installing the BoostLogic Anti-Lag System in your Mitsubishi Lancer Evolution X can significantly enhance your driving experience. By following this guide, you can ensure a successful installation and enjoy the benefits of improved turbo responsiveness. Always remember to drive safely and responsibly.